Hanomag C 220 or International Harvester F-137 D?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the C 220 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the F-137 D has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- The Hanomag C 220 suits loader and hydraulic implement work better on this data: 17% (2.0 L/min / 0.5 gpm) more hydraulic flow.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | C 220 | F-137 D | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 14.6 kW (19.6 hp)Traktorenlexikon, “Hanomag C 220” | 14.7 kW (19.7 hp)Traktorenlexikon, “McCormick F-137 D” | Not comparableNot comparable on power at the PTO shaft: the C 220 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the F-137 D has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the C 220 and the F-137 D. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the C 220 and the F-137 D. |
| Which pumps more oil for implements? | 14.0 L/min (3.7 gpm)Traktorenlexikon, “Hanomag C 220” | 12.0 L/min (3.2 gpm)Traktorenlexikon, “McCormick F-137 D” | AheadThe Hanomag C 220 has 17% more hydraulic flow (2.0 L/min / 0.5 gpm) than the International Harvester F-137D (both pump flow, as stated by the source). |
| Which lifts more on the three-point hitch? | 1,020 kg (2,249 lb)Traktorenlexikon, “Hanomag C 220” | — | No figureNo call on three-point lift: no figure on record for the F-137 D. |
| Which is heavier, for traction? | 1,370 kg (3,020 lb)Traktorenlexikon, “Hanomag C 220” | 1,080 kg (2,381 lb)Traktorenlexikon, “McCormick F-137 D” | Ahead (a fact, not an advantage)The Hanomag C 220 is 27% heavier (290 kg / 639 lb) than the International Harvester F-137D (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | 1,650 kg (3,638 lb) to 2,000 kg (4,409 lb)Traktorenlexikon, “Hanomag C 220” | — | No figureNo call on maximum permissible mass: no figure on record for the F-137 D. |
| Which has the wider choice of gears? | 6Traktorenlexikon, “Hanomag C 220” | 6Traktorenlexikon, “McCormick F-137 D” | EvenEven on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call. |
| Which offers a creeper range? | — | YesTraktorenlexikon, “McCormick F-137 D” | No figureNo call on a creeper range: not stated for the C 220. |
| Which is faster on the road? | 19.8 km/h (12.3 mph)Traktorenlexikon, “Hanomag C 220” | 18 km/h (11.2 mph)Traktorenlexikon, “McCormick F-137 D” | EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which offers more PTO speeds? | 1260Traktorenlexikon, “Hanomag C 220” | 542 rpmTraktorenlexikon, “McCormick F-137 D” | No figureNo call on PTO speeds: no standard PTO speed stated for the C 220 and the F-137 D. |
| Which PTO runs independently of the ground drive? | — | dependent (stops with the clutch)Traktorenlexikon, “McCormick F-137 D” | No figureNo call on PTO independence: not stated for the C 220. |
| Which drives on both axles? | 2WDTraktorenlexikon, “Hanomag C 220” | 2WDTraktorenlexikon, “McCormick F-137 D” | EvenEven on drive: all two-wheel drive. |
| Which is newer, and what about parts? | 1959–1960 | 1960–1964 | EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Hanomag C 220 has 17% more hydraulic flow (2.0 L/min / 0.5 gpm) than the International Harvester F-137D (both pump flow, as stated by the source).
- The Hanomag C 220 is 27% heavier (290 kg / 639 lb) than the International Harvester F-137D (both unladen weight, as stated by the source).
- Even on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
- Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on drive: all two-wheel drive.
- Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
- Not comparable on power at the PTO shaft: the C 220 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the F-137 D has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, three-point lift, maximum permissible mass, a creeper range, PTO speeds and PTO independence.
← Every figure for both machines, side by side, with sources