9 material differences · fewer than 12
Tractor oneHanomag C 2201959–1960No measured PTO figureTractor twoInternational Harvester D-320 Farmall1956–1962No measured PTO figure
Which should you choose?
Read our verdict on the C 220 and the D-320 Farmall → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | C 220 | D-320 Farmall | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 19.6 hp | 19.7 hp | — |
| Engine declared | Hanomag D 621 | INTERNATIONAL-HARVESTER DD-99 | differs |
| Displacement declared | 1.02 L | 1.63 L | +60% D-320 Farmall |
| Maximum torque declared | 58 lb·ft · 78 N·m | 63 lb·ft · 86 N·m | +10% D-320 Farmall |
| Transmission | |||
| Top speed declared | 12.3 mph · 19.8 km/h | 12.4 mph · 20 km/h | — |
| Clutch declared | Single dry clutch from Fichtel & Sachs | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 3.7 gpm · 14.0 L/min | — | — |
| Rear PTO speeds declared | 1260 | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 3,020 lb · 1,370 kg | 2,884 lb · 1,308 kg | — |
| Maximum permissible mass declared | 3,638–4,409 lb · 1,650–2,000 kg | — | — |
| Wheelbase declared | 77.2 in · 1,960 mm | 70.1 in · 1,780 mm | +10% C 220 |
| Length declared | 122.0 in · 3,100 mm | 108.3 in · 2,750 mm | +13% C 220 |
| Width declared | 63.0–73.2 in · 1,600–1,860 mm | 64.6 in · 1,640 mm | differs |
| Ground clearance declared | 15.7 in · 400 mm | 15.1 in · 383 mm | — |
| Turning radius, braked declared | 8.9 ft · 2.70 m | 8.4 ft · 2.55 m | +6% C 220 |
| Fuel tank declared | 47.6 qt · 45 L | 28.5 qt · 27.0 L | +67% C 220 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Hanomag C 220 sources
- Source: Traktorenlexikon, “Hanomag C 220”
- Source: Traktorenlexikon, “Hanomag C 218”
International Harvester D-320 Farmall sources
- Source: Traktorenlexikon, “McCormick D-320 Farmall”
- Source: Traktorenlexikon, “McCormick DED 3”