9 material differences · fewer than 12
Tractor oneFiat 940 (DT)1978–1979No measured PTO figureTractor twoInternational Harvester Farmall 8261969–1971No measured PTO figure
Which should you choose?
Read our verdict on the 940 (DT) and the Farmall 826 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | 940 (DT) | Farmall 826 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 90.8 hp | 90.8 hp | — |
| Engine declared | O.M.-FIAT CO 3/80 | INTERNATIONAL HARVESTER C-301 | differs |
| Displacement declared | 4.94 L | — | — |
| Maximum torque declared | — | 251 lb·ft · 340 N·m | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 18.6 mph · 30 km/h | +20% Farmall 826 |
| Clutch declared | Dry FEREDO double clutch | Pedal-operated dry single-plate clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 10.0 gpm · 38.0 L/min | — | — |
| Pressure declared | 2,901 psi · 200 bar | — | — |
| Rear PTO speeds declared | — | 540 rpm / 1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 8,708 lb · 3,950 kg | 9,859 lb · 4,472 kg | +13% Farmall 826 |
| Wheelbase declared | 93.3 in · 2,370 mm | 101.2 in · 2,570 mm | +8% Farmall 826 |
| Length declared | 159.4 in · 4,050 mm | 164.0 in · 4,166 mm | — |
| Width declared | 76.2–99.7 in · 1,935–2,532 mm | 110.0 in · 2,794 mm | differs |
| Ground clearance declared | 22.4 in · 570 mm | 24.0 in · 610 mm | +7% Farmall 826 |
| Turning radius, braked declared | 12.6 ft · 3.84 m | 9.8 ft · 2.97 m | +29% 940 (DT) |
| Fuel tank declared | 95.1 qt · 90.0 L | 147.9 qt · 140.0 L | +56% Farmall 826 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fiat 940 (DT) sources
- Source: Traktorenlexikon, “Fiat 940/940 DT”
- Source: Traktorenlexikon, “Someca 940”
International Harvester Farmall 826 sources
- Source: Traktorenlexikon, “Farmall Farmall 826”
- Source: Traktorenlexikon, “IHC 806”