9 material differences · fewer than 12

Tractor oneFiat 400 (DT)1968–1974No measured PTO figureTractor twoMassey Ferguson MF 1331969–1974No measured PTO figure

Which should you choose?

We will not advise between these two machines, because the drive differs (Two-wheel or four-wheel drive; 2WD). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.

Field by field

9 material differences · 7 fields identical or within 5%, which is not counted as material

Fiat 400 (DT) and Massey Ferguson MF 133, field by field
Field400 (DT)MF 133Gap
Engine
Engine power, claimed claimed34.5 hp34.6 hp—
Engine declaredFIAT-IVECO 8035.01.201Perkins A 3.144differs
Displacement declared2.34 L2.37 L—
Maximum torque declared103 lb·ft · 140 N·m108 lb·ft · 146 N·m—
Transmission
Top speed declared15.5 mph · 25 km/h12.4 mph · 20 km/h+25% 400 (DT)
Clutch declaredPedal-operated two-stage dry Feredo double clutchPedal operated, dry and air-cooled MF dual clutchdiffers
Hydraulics & hitch
Pump flow declared5.8 gpm · 21.8 L/min3.9 gpm · 14.8 L/min+47% 400 (DT)
Pressure declared2,843 psi · 196 bar2,589 psi · 178 bar+10% 400 (DT)
Three-point lift, at the coupling points declared2,866 lb · 1,300 kg2,866 lb · 1,300 kg—
Rear PTO speeds declared540 rpm540 rpm—
Weight & dimensions
Unladen weight declared3,750 lb · 1,701 kg4,090 lb · 1,855 kg+9% MF 133
Maximum permissible mass declared—6,614 lb · 3,000 kg—
Wheelbase declared75.6 in · 1,920 mm72.0 in · 1,830 mm—
Length declared124.8 in · 3,169 mm122.0 in · 3,100 mm—
Width declared62.4–88.2 in · 1,585–2,240 mm66.1 in · 1,680 mmdiffers
Ground clearance declared14.6 in · 370 mm11.8 in · 300 mm+23% 400 (DT)
Turning radius, braked declared9.7 ft · 2.95 m8.7 ft · 2.67 m+10% 400 (DT)
Fuel tank declared—40.8 qt · 38.6 L—

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

Fiat 400 (DT) sources

Source
  • Source: Traktorenlexikon, “Fiat 400/400 DT”

Massey Ferguson MF 133 sources

Source
  • Source: Traktorenlexikon, “Massey Ferguson MF 133”
  • Source: Traktorenlexikon, “Massey Ferguson MF 133 V/S”
  • Source: Traktorenlexikon, “Massey Ferguson MF 133 SUPER”