7 material differences · fewer than 12
Tractor oneFiat 400 (DT)1968–1974No measured PTO figureTractor twoHermann Lanz D 634 L1977–1980No measured PTO figure
Which should you choose?
Read our verdict on the 400 (DT) and the D 634 L → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
7 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | 400 (DT) | D 634 L | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 34.5 hp | 34.3 hp | — |
| Engine declared | FIAT-IVECO 8035.01.201 | MWM D 325-3 | differs |
| Displacement declared | 2.34 L | 2.55 L | +9% D 634 L |
| Maximum torque declared | 103 lb·ft · 140 N·m | — | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 15.5 mph · 25 km/h | — |
| Clutch declared | Pedal-operated two-stage dry Feredo double clutch | Dual clutch by Fichtel & Sachs | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 5.8 gpm · 21.8 L/min | — | — |
| Pressure declared | 2,843 psi · 196 bar | — | — |
| Rear PTO speeds declared | 540 rpm | 545/1050 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 3,750 lb · 1,701 kg | 3,924 lb · 1,780 kg | — |
| Wheelbase declared | 75.6 in · 1,920 mm | 81.9 in · 2,080 mm | +8% D 634 L |
| Length declared | 124.8 in · 3,169 mm | 129.9 in · 3,300 mm | — |
| Width declared | 62.4–88.2 in · 1,585–2,240 mm | 59.8 in · 1,520 mm | differs |
| Ground clearance declared | 14.6 in · 370 mm | 13.0 in · 330 mm | +12% 400 (DT) |
| Turning radius, braked declared | 9.7 ft · 2.95 m | — | — |
| Fuel tank declared | — | 37.0 qt · 35 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fiat 400 (DT) sources
- Source: Traktorenlexikon, “Fiat 400/400 DT”
Hermann Lanz D 634 L sources
- Source: Traktorenlexikon, “HELA D 634 L (D 635 L)”
- Source: Traktorenlexikon, “Renault 60 R7253”