10 material differences · fewer than 12
Tractor oneFendt Farmer 1 D1971–1974No measured PTO figureTractor twoSOMECA 400 (DT)1968–1971No measured PTO figure
Which should you choose?
Read our verdict on the Farmer 1 D and the 400 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | Farmer 1 D | 400 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 33.4 hp | 34 hp | — |
| Engine declared | MWM D 325-3 | O.M.-FIAT 8035.01.201 | differs |
| Displacement declared | 2.55 L | 2.34 L | +9% Farmer 1 D |
| Maximum torque declared | — | 103 lb·ft · 140 N·m | — |
| Transmission | |||
| Top speed declared | 12.4–15.5 mph · 20–25 km/h | 15.5 mph · 25 km/h | differs |
| Clutch declared | Single-plate dry clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 4.6 gpm · 17.6 L/min | 5.8 gpm · 21.8 L/min | +24% 400 (DT) |
| Pressure declared | 2,538 psi · 175 bar | 2,843 psi · 196 bar | +12% 400 (DT) |
| Rear PTO speeds declared | 540/600 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 3,913 lb · 1,775 kg | 3,748 lb · 1,700 kg | — |
| Maximum permissible mass declared | 5,732 lb · 2,600 kg | — | — |
| Wheelbase declared | 78.5 in · 1,994 mm | 75.6 in · 1,920 mm | — |
| Length declared | 130.2 in · 3,308 mm | 126.0 in · 3,200 mm | — |
| Width declared | 59.9 in · 1,522 mm | 62.4–88.2 in · 1,585–2,240 mm | differs |
| Ground clearance declared | 16.3 in · 415 mm | 14.6 in · 370 mm | +12% Farmer 1 D |
| Turning radius, braked declared | 11.0 ft · 3.35 m | 9.7 ft · 2.95 m | +14% Farmer 1 D |
| Fuel tank declared | 32.8 qt · 31.0 L | 57.1 qt · 54.0 L | +74% 400 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fendt Farmer 1 D sources
- Source: Traktorenlexikon, “Fendt Farmer 1 D”
- Source: Traktorenlexikon, “Renault 60 R7253”
SOMECA 400 (DT) sources
- Source: Traktorenlexikon, “Someca 400”