Fendt Farmer 1 D or SOMECA 400 (DT)?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the Farmer 1 D has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 400 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- The SOMECA 400 (DT) suits heavy draft work (ploughing, cultivating) better on this data: four-wheel drive.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | Farmer 1 D | 400 (DT) | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 24.9 kW (33.4 hp)Traktorenlexikon, “Fendt Farmer 1 D” | 25 kW (34 hp)Traktorenlexikon, “Someca 400” | Not comparableNot comparable on power at the PTO shaft: the Farmer 1 D has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 400 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the Farmer 1 D and the 400 (DT). |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the Farmer 1 D and the 400 (DT). |
| Which pumps more oil for implements? | 17.6 L/min (4.6 gpm)Traktorenlexikon, “Fendt Farmer 1 D” | 21.8 L/min (5.8 gpm)Traktorenlexikon, “Someca 400” | AheadThe SOMECA 400 (DT) has 24% more hydraulic flow (4.2 L/min / 1.1 gpm) than the Fendt Farmer 1 D (both pump flow, as stated by the source). |
| Which lifts more on the three-point hitch? | 1,500 kg (3,307 lb)Traktorenlexikon, “Fendt Farmer 1 D” | 1,300 kg (2,866 lb)Traktorenlexikon, “Someca 400” | AheadThe Fendt Farmer 1 D has 15% more lift (200 kg / 441 lb) than the SOMECA 400 (DT) (both lift at the hitch ends, as stated by the source). |
| Which is heavier, for traction? | 1,775 kg (3,913 lb)Traktorenlexikon, “Fendt Farmer 1 D” | 1,700 kg (3,748 lb)Traktorenlexikon, “Someca 400” | EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which may carry more ballast and load? | 2,600 kg (5,732 lb)Traktorenlexikon, “Fendt Farmer 1 D” | — | No figureNo call on maximum permissible mass: no figure on record for the 400 (DT). |
| Which has the wider choice of gears? | 6Traktorenlexikon, “Fendt Farmer 1 D” | 6 to 9Traktorenlexikon, “Someca 400” | EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers a creeper range? | YesTraktorenlexikon, “Fendt Farmer 1 D” | — | No figureNo call on a creeper range: not stated for the 400 (DT). |
| Which is faster on the road? | 20 km/h (12.4 mph) to 25 km/h (15.5 mph)Traktorenlexikon, “Fendt Farmer 1 D” | 25 km/h (15.5 mph)Traktorenlexikon, “Someca 400” | EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers more PTO speeds? | 540/600 rpmTraktorenlexikon, “Fendt Farmer 1 D” | 540 rpmTraktorenlexikon, “Someca 400” | EvenEven on PTO speeds: the same speeds (540 rpm). |
| Which PTO runs independently of the ground drive? | dependent (stops with the clutch)Traktorenlexikon, “Fendt Farmer 1 D” | — | No figureNo call on PTO independence: not stated for the 400 (DT). |
| Which drives on both axles? | 2WDTraktorenlexikon, “Fendt Farmer 1 D” | Two-wheel or four-wheel driveTraktorenlexikon, “Someca 400” | AheadThe SOMECA 400 (DT) is available with four-wheel drive; the Fendt Farmer 1 D is two-wheel drive (as stated by the sources). |
| Which is newer, and what about parts? | 1971–1974 | 1968–1971 | EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The SOMECA 400 (DT) has 24% more hydraulic flow (4.2 L/min / 1.1 gpm) than the Fendt Farmer 1 D (both pump flow, as stated by the source).
- The Fendt Farmer 1 D has 15% more lift (200 kg / 441 lb) than the SOMECA 400 (DT) (both lift at the hitch ends, as stated by the source).
- The SOMECA 400 (DT) is available with four-wheel drive; the Fendt Farmer 1 D is two-wheel drive (as stated by the sources).
- Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on PTO speeds: the same speeds (540 rpm).
- Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
- Not comparable on power at the PTO shaft: the Farmer 1 D has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 400 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, maximum permissible mass, a creeper range and PTO independence.
← Every figure for both machines, side by side, with sources