9 material differences · fewer than 12
Tractor oneFahr D 1771958–1961No measured PTO figureTractor twoInternational Harvester 2761968–1974No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (1958–1961; 1968–1974). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
9 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | D 177 | 276 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 34 hp | 35.5 hp | +6% 276 |
| Engine declared | Daimler-Benz OM 636 VI-E | INTERNATIONAL HARVESTER BD-144 A | differs |
| Displacement declared | 1.77 L | 2.35 L | +33% 276 |
| Maximum torque declared | 69 lb·ft · 93 N·m | 97 lb·ft · 132 N·m | +42% 276 |
| Transmission | |||
| Top speed declared | 12.2 mph · 19.6 km/h | 15.5 mph · 25 km/h | +28% 276 |
| Clutch declared | Pedal operated dry Fichtel & Sachs double clutch | Pedal-operated two-stage dry BORG & BECK double clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | — | 6.6 gpm · 25.0 L/min | — |
| Pressure declared | 3,556 psi · 245 bar | — | — |
| Rear PTO speeds declared | — | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 3,638 lb · 1,650 kg | 3,741 lb · 1,697 kg | — |
| Maximum permissible mass declared | 5,732 lb · 2,600 kg | — | — |
| Wheelbase declared | 76.8 in · 1,950 mm | 76.5 in · 1,943 mm | — |
| Length declared | 126.0 in · 3,200 mm | 121.3 in · 3,080 mm | — |
| Width declared | 61.1 in · 1,552 mm | 74.0 in · 1,880 mm | +21% 276 |
| Ground clearance declared | 15.7 in · 400 mm | 13.7 in · 349 mm | +15% D 177 |
| Turning radius, braked declared | 9.3 ft · 2.83 m | 10.4 ft · 3.16 m | +12% 276 |
| Fuel tank declared | 46.5 qt · 44 L | 51.0 qt · 48.3 L | +10% 276 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fahr D 177 sources
- Source: Traktorenlexikon, “Fahr D 177”
- Source: Traktorenlexikon, “Fahr D 177 S”
International Harvester 276 sources
- Source: Traktorenlexikon, “McCormick 276”
- Source: Traktorenlexikon, “IHC 276”