6 material differences · fewer than 12
Tractor oneFahr D 130 A1957–1959No measured PTO figureTractor twoKramer KA 171956No measured PTO figure
Which should you choose?
Read our verdict on the D 130 A and the KA 17 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
6 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | D 130 A | KA 17 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 16.8 hp | 17.7 hp | +6% KA 17 |
| Engine declared | Güldner 2 LD | Güldner 2 DN | differs |
| Displacement declared | 1.31 L | 1.30 L | — |
| Maximum torque declared | 48 lb·ft · 65 N·m | 50 lb·ft · 68 N·m | — |
| Transmission | |||
| Top speed declared | 11.6 mph · 18.7 km/h | 11.8 mph · 19 km/h | — |
| Clutch declared | — | Single-plate dry clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | — | 3.7 gpm · 14.0 L/min | — |
| Pressure declared | 3,129 psi · 216 bar | 1,707 psi · 118 bar | +83% D 130 A |
| Rear PTO speeds declared | 538 rpm | 530 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 2,513 lb · 1,140 kg | 2,701 lb · 1,225 kg | +7% KA 17 |
| Maximum permissible mass declared | 3,748 lb · 1,700 kg | — | — |
| Wheelbase declared | 68.4 in · 1,737 mm | 67.9 in · 1,725 mm | — |
| Length declared | 107.4 in · 2,727 mm | 105.5 in · 2,680 mm | — |
| Width declared | 57.5 in · 1,460 mm | 57.9 in · 1,470 mm | — |
| Ground clearance declared | 15.4 in · 390 mm | 11.8 in · 300 mm | +30% D 130 A |
| Turning radius, braked declared | 7.7 ft · 2.35 m | — | — |
| Fuel tank declared | 31.7 qt · 30 L | 25.4 qt · 24 L | +25% D 130 A |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fahr D 130 A sources
- Source: Traktorenlexikon, “Fahr D 130 A”
- Source: Traktorenlexikon, “Fahr D 131 L”
Kramer KA 17 sources
- Source: Traktorenlexikon, “Kramer KA 17”
- Source: Traktorenlexikon, “MAN AS 718 A”