7 material differences · fewer than 12
Tractor oneDeutz-Fahr IN-trac 6.051987No measured PTO figureTractor twoLandini 10800 (DT)1987–2000No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (4WD; Two-wheel or four-wheel drive). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
7 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | IN-trac 6.05 | 10800 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 97 hp | 95.7 hp | — |
| Engine declared | Deutz F6L 912 | PERKINS TW 6.354-4 | differs |
| Displacement declared | 5.66 L | 5.80 L | — |
| Maximum torque declared | — | 245 lb·ft · 332 N·m | — |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 18.6 mph · 30 km/h | +33% IN-trac 6.05 |
| Clutch declared | — | pedal-operated dry single-disc clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | 14.8 gpm · 56.0 L/min | 13.5 gpm · 51.2 L/min | +9% IN-trac 6.05 |
| Pressure declared | — | 2,901 psi · 200 bar | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 10,803 lb · 4,900 kg | 9,480 lb · 4,300 kg | +14% IN-trac 6.05 |
| Maximum permissible mass declared | 19,180 lb · 8,700 kg | 15,432 lb · 7,000 kg | +24% IN-trac 6.05 |
| Wheelbase declared | 106.4 in · 2,703 mm | 106.1 in · 2,696 mm | — |
| Length declared | 196.9 in · 5,000 mm | 175.2 in · 4,450 mm | +12% IN-trac 6.05 |
| Width declared | 90.6 in · 2,300 mm | 83.9 in · 2,130 mm | +8% IN-trac 6.05 |
| Ground clearance declared | — | 16.1 in · 410 mm | — |
| Fuel tank declared | — | 200.8 qt · 190.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr IN-trac 6.05 sources
- Source: Traktorenlexikon, “Deutz-Fahr IN-trac 6.05”
Landini 10800 (DT) sources
- Source: Traktorenlexikon, “Landini 10800 DT”