6 material differences · fewer than 12
Tractor oneDeutz-Fahr IN-trac 6.051987No measured PTO figureTractor twoFord 78101988–1991No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (39%); the drive differs (4WD; Two-wheel or four-wheel drive); they were not built in overlapping years (1987–1987; 1988–1991). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
6 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | IN-trac 6.05 | 7810 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 97 hp | 96.7 hp | — |
| Engine declared | Deutz F6L 912 | — | — |
| Displacement declared | 5.66 L | — | — |
| Maximum torque declared | — | 294 lb·ft · 399 N·m | — |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 18.6 mph · 30 km/h | +33% IN-trac 6.05 |
| Hydraulics & hitch | |||
| Pump flow declared | 14.8 gpm · 56.0 L/min | 18.2 gpm · 68.9 L/min | +23% 7810 |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 10,803 lb · 4,900 kg | 7,749 lb · 3,515 kg | +39% IN-trac 6.05 |
| Maximum permissible mass declared | 19,180 lb · 8,700 kg | — | — |
| Wheelbase declared | 106.4 in · 2,703 mm | 99.1 in · 2,516 mm | +7% IN-trac 6.05 |
| Length declared | 196.9 in · 5,000 mm | 165.5 in · 4,204 mm | +19% IN-trac 6.05 |
| Width declared | 90.6 in · 2,300 mm | 76.9 in · 1,953 mm | +18% IN-trac 6.05 |
| Ground clearance declared | — | 24.0 in · 610 mm | — |
| Fuel tank declared | — | 188.1 qt · 178.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr IN-trac 6.05 sources
- Source: Traktorenlexikon, “Deutz-Fahr IN-trac 6.05”
Ford 7810 sources
- Source: Traktorenlexikon, “Ford 7810”