14 material differences

Tractor oneDeutz-Fahr DX 6.101983–1990No measured PTO figureTractor twoSAME Antares 1001989–1995No measured PTO figure

Which should you choose?

We will not advise between these two machines, because their unladen weight differs by more than 25% (40%); the drive differs (Two-wheel or four-wheel drive; 4WD). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.

Field by field

14 material differences · 2 fields identical or within 5%, which is not counted as material

Deutz-Fahr DX 6.10 and SAME Antares 100, field by field
FieldDX 6.10Antares 100Gap
Engine
Engine power, claimed claimed98.2 hp98.6 hp—
Engine declaredKHD F6L 912.74SAME 1000.4 ATIdiffers
Displacement declared5.65 L4.00 L+41% DX 6.10
Maximum torque declared263 lb·ft · 356 N·m258 lb·ft · 350 N·m—
Transmission
Top speed declared18.6–24.9 mph · 30–40 km/h24.9 mph · 40 km/hdiffers
Clutch declared—Pedal-operated dry S.L.H. single-disc clutch—
Hydraulics & hitch
Pump flow declared14.7 gpm · 55.6 L/min11.2 gpm · 42.5 L/min+31% DX 6.10
Pressure declared—2,176 psi · 150 bar—
Three-point lift, at the coupling points declared11,464 lb · 5,200 kg10,494 lb · 4,760 kg+9% DX 6.10
Rear PTO speeds declared540/1000 rpm540/1000/540E/1000E rpmdiffers
Weight & dimensions
Unladen weight declared10,472 lb · 4,750 kg7,496 lb · 3,400 kg+40% DX 6.10
Maximum permissible mass declared14,991 lb · 6,800 kg11,905 lb · 5,400 kg+26% DX 6.10
Wheelbase declared106.4 in · 2,703 mm91.3 in · 2,320 mm+17% DX 6.10
Length declared179.1 in · 4,550 mm152.0 in · 3,860 mm+18% DX 6.10
Width declared90.7 in · 2,304 mm74.8–102.4 in · 1,900–2,600 mmdiffers
Ground clearance declared20.1 in · 510 mm18.5 in · 470 mm+9% DX 6.10
Turning radius, braked declared15.9 ft · 4.86 m9.6 ft · 2.94 m+65% DX 6.10
Fuel tank declared126.8 qt · 120 L116.2 qt · 110.0 L+9% DX 6.10

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

Deutz-Fahr DX 6.10 sources

Source
  • Source: Traktorenlexikon, “Deutz-Fahr DX 6.10”

SAME Antares 100 sources

Source
  • Source: Traktorenlexikon, “SAME Antares 100”