7 material differences · fewer than 12
Tractor oneDeutz-Fahr DX 6.101983–1990No measured PTO figureTractor twoLandini 10.000 (DT)1978–1993No measured PTO figure
Which should you choose?
Read our verdict on the DX 6.10 and the 10.000 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
7 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | DX 6.10 | 10.000 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 98.2 hp | 98.6 hp | — |
| Engine declared | KHD F6L 912.74 | Perkins TW 31087 U (A. 6.354.4/A. 6.354.4 HTR) | differs |
| Displacement declared | 5.65 L | 5.79 L | — |
| Maximum torque declared | 263 lb·ft · 356 N·m | 289 lb·ft · 392 N·m | +10% 10.000 (DT) |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 18.6 mph · 30 km/h | differs |
| Clutch declared | — | Pedal-operated, dry and air-cooled double clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | 14.7 gpm · 55.6 L/min | 12.3 gpm · 46.5 L/min | +20% DX 6.10 |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 10,472 lb · 4,750 kg | 9,976 lb · 4,525 kg | — |
| Maximum permissible mass declared | 14,991 lb · 6,800 kg | — | — |
| Wheelbase declared | 106.4 in · 2,703 mm | 104.7 in · 2,660 mm | — |
| Length declared | 179.1 in · 4,550 mm | 171.3 in · 4,350 mm | — |
| Width declared | 90.7 in · 2,304 mm | 83.9 in · 2,130 mm | +8% DX 6.10 |
| Ground clearance declared | 20.1 in · 510 mm | 16.9 in · 430 mm | +19% DX 6.10 |
| Turning radius, braked declared | 15.9 ft · 4.86 m | — | — |
| Fuel tank declared | 126.8 qt · 120 L | 179.6 qt · 170.0 L | +42% 10.000 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr DX 6.10 sources
- Source: Traktorenlexikon, “Deutz-Fahr DX 6.10”
Landini 10.000 (DT) sources
- Source: Traktorenlexikon, “Landini 10000”