Deutz-Fahr DX 3.10 vs Fiat 500 Spezial (DT)

13 material differences

Tractor one

1984–1990

No measured PTO figure

Tractor two

1971–1980

No measured PTO figure

Which should you choose?

Read our verdict on the DX 3.10 and the 500 Spezial (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.

13 material differences · 2 fields identical or within 5%, which is not counted as material

Deutz-Fahr DX 3.10 and Fiat 500 Spezial (DT), field by field
Field	DX 3.10	500 Spezial (DT)	Gap
Engine
Engine power, claimed claimed	46 hp	49.3 hp	+8% 500 Spezial (DT)
Engine declared	KHD F3L 912	FIAT-IVECO 8035.02.204	differs
Displacement declared	2.83 L	2.59 L	+9% DX 3.10
Maximum torque declared	123 lb·ft · 167 N·m	116 lb·ft · 157 N·m	+6% DX 3.10
Transmission
Top speed declared	18.6 mph · 30 km/h	15.5 mph · 25 km/h	+20% DX 3.10
Clutch declared	Independent dry double clutch	Dry LuK double clutch with 279.4 mm disc diameter	differs
Hydraulics & hitch
Hydraulic control declared	Constant flow	—	—
Pump flow declared	9.1 gpm · 34.4 L/min	—	—
Pressure declared	3,481 psi · 240 bar	2,843 psi · 196 bar	+22% DX 3.10
Three-point lift at ends declared	4,189 lb · 1,900 kg	3,571 lb · 1,620 kg	+17% DX 3.10
Rear PTO speeds declared	540/1000 rpm	540 rpm	differs
Weight & dimensions
Unladen weight declared	5,600 lb · 2,540 kg	4,145 lb · 1,880 kg	+35% DX 3.10
Maximum permissible mass declared	8,818 lb · 4,000 kg	—	—
Wheelbase declared	79.2 in · 2,012 mm	75.6 in · 1,920 mm	—
Length declared	137.4 in · 3,490 mm	119.7 in · 3,041 mm	+15% DX 3.10
Width declared	70.4 in · 1,788 mm	62.4 in · 1,585 mm	+13% DX 3.10
Height declared	91.1 in · 2,315 mm	92.5 in · 2,350 mm	—
Ground clearance declared	16.1 in · 410 mm	18.1 in · 459 mm	+12% 500 Spezial (DT)
Turning radius, braked declared	—	9.7 ft · 2.95 m	—
Fuel tank declared	87.7 qt · 83 L	57.1 qt · 54.0 L	+54% DX 3.10

Source

Source