11 material differences · fewer than 12
Tractor oneDeutz-Fahr DX 1101978–1983No measured PTO figureTractor twoVALMET 1102 (-4)1973–1980No measured PTO figure
Which should you choose?
Read our verdict on the DX 110 and the 1102 (-4) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
11 material differences · 1 fields identical or within 5%, which is not counted as material
| Field | DX 110 | 1102 (-4) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 101 hp | 100.6 hp | — |
| Engine declared | KHD F6L 912 | VALMET 411 BS or 411 CS | differs |
| Displacement declared | 5.65 L | — | — |
| Maximum torque declared | 257 lb·ft · 349 N·m | — | — |
| Transmission | |||
| Top speed declared | 15.5–18.6 mph · 25–30 km/h | 18.6 mph · 30 km/h | differs |
| Clutch declared | Independent dry double clutch | dry Fichtel & Sachs double clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 14.7 gpm · 55.7 L/min | 9.2 gpm · 35.0 L/min | +59% DX 110 |
| Pressure declared | 3,046–3,771 psi · 210–260 bar | — | — |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 9,744 lb · 4,420 kg | 8,598 lb · 3,900 kg | +13% DX 110 |
| Maximum permissible mass declared | 14,991 lb · 6,800 kg | — | — |
| Wheelbase declared | 105.8 in · 2,688 mm | 91.3 in · 2,320 mm | +16% DX 110 |
| Length declared | 176.8 in · 4,490 mm | 154.7 in · 3,930 mm | +14% DX 110 |
| Width declared | 90.7 in · 2,304 mm | 78.0 in · 1,980 mm | +16% DX 110 |
| Ground clearance declared | 23.2 in · 590 mm | 20.5 in · 520 mm | +13% DX 110 |
| Turning radius, braked declared | 14.0 ft · 4.28 m | 12.1 ft · 3.70 m | +16% DX 110 |
| Fuel tank declared | — | 102.5 qt · 97.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr DX 110 sources
- Source: Traktorenlexikon, “Deutz-Fahr DX 110”
VALMET 1102 (-4) sources
- Source: Traktorenlexikon, “Valmet 1102”