12 material differences
Tractor oneDeutz-Fahr Agroplus 802001–2005No measured PTO figureTractor twoDeutz-Fahr DX 3.75 A1993–1996No measured PTO figure
Which should you choose?
Read our verdict on the Agroplus 80 and the DX 3.75 A → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
12 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | Agroplus 80 | DX 3.75 A | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 76.0 hp | 76.6 hp | — |
| Engine declared | KHD F4L 913 or F4L 914 | KHD F4L 913 | differs |
| Displacement declared | — | 4.09 L | — |
| Maximum torque declared | 204 lb·ft · 276 N·m | 183 lb·ft · 248 N·m | +11% Agroplus 80 |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Clutch declared | Mechanically-operated dry Borg & Beck single clutch, type: 305 | Independent dry double clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | Open centre | — |
| Pump flow declared | 12.7 gpm · 48.0 L/min | 10.6 gpm · 40.0 L/min | +20% Agroplus 80 |
| Pressure declared | 2,031 psi · 140 bar | 3,481 psi · 240 bar | +71% DX 3.75 A |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,063 lb · 2,750 kg | 7,077 lb · 3,210 kg | +17% DX 3.75 A |
| Maximum permissible mass declared | 9,921 lb · 4,500 kg | 11,023 lb · 5,000 kg | +11% DX 3.75 A |
| Wheelbase declared | 88.0 in · 2,235 mm | 88.6 in · 2,250 mm | — |
| Length declared | 159.8 in · 4,060 mm | 141.7 in · 3,600 mm | +13% Agroplus 80 |
| Width declared | 79.1 in · 2,008 mm | 84.2 in · 2,138 mm | +6% DX 3.75 A |
| Ground clearance declared | 17.5 in · 445 mm | 16.1 in · 408 mm | +9% Agroplus 80 |
| Turning radius, braked declared | — | 12.8 ft · 3.90 m | — |
| Fuel tank declared | 95.1 qt · 90 L | 91.9 qt · 87 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr Agroplus 80 sources
Source
- Source: Traktorenlexikon, “Deutz-Fahr Agroplus 80”
- Source: Traktorenlexikon, “Deutz-Fahr Agroplus 70”
Deutz-Fahr DX 3.75 A sources
Source
- Source: Traktorenlexikon, “Deutz-Fahr DX 3.75 A”
- Source: Traktorenlexikon, “Deutz-Fahr DX 3.90”