10 material differences · fewer than 12
Tractor oneDeutz-Fahr Agroplus 1001997–2005No measured PTO figureTractor twoDeutz-Fahr DX 6.101983–1990No measured PTO figure
Which should you choose?
Read our verdict on the Agroplus 100 and the DX 6.10 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | Agroplus 100 | DX 6.10 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 97.8 hp | 98.2 hp | — |
| Engine declared | — | KHD F6L 912.74 | — |
| Displacement declared | — | 5.65 L | — |
| Maximum torque declared | 282 lb·ft · 383 N·m | 263 lb·ft · 356 N·m | +8% Agroplus 100 |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | — | 14.7 gpm · 55.6 L/min | — |
| Three-point lift, at the coupling points declared | 14,330 lb · 6,500 kg | 11,464 lb · 5,200 kg | +25% Agroplus 100 |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 9,855 lb · 4,470 kg | 10,472 lb · 4,750 kg | +6% DX 6.10 |
| Maximum permissible mass declared | 15,873 lb · 7,200 kg | 14,991 lb · 6,800 kg | +6% Agroplus 100 |
| Wheelbase declared | 101.1 in · 2,568 mm | 106.4 in · 2,703 mm | — |
| Length declared | 155.2 in · 3,943 mm | 179.1 in · 4,550 mm | +15% DX 6.10 |
| Width declared | 81.1 in · 2,060 mm | 90.7 in · 2,304 mm | +12% DX 6.10 |
| Ground clearance declared | 19.1 in · 484 mm | 20.1 in · 510 mm | +5% DX 6.10 |
| Turning radius, braked declared | — | 15.9 ft · 4.86 m | — |
| Fuel tank declared | 147.9 qt · 140 L | 126.8 qt · 120 L | +17% Agroplus 100 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr Agroplus 100 sources
- Source: Traktorenlexikon, “Deutz-Fahr Agroplus 100”
Deutz-Fahr DX 6.10 sources
- Source: Traktorenlexikon, “Deutz-Fahr DX 6.10”