8 material differences · fewer than 12
Tractor oneDeutz (KHD) D 25061968–1974No measured PTO figureTractor twoInternational Harvester D-324 Standard1958–1962No measured PTO figure
Which should you choose?
Read our verdict on the D 2506 and the D-324 Standard → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | D 2506 | D-324 Standard | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 21 hp | 23.7 hp | +11% D-324 Standard |
| Engine declared | KHD F2L 912 | INTERNATIONAL-HARVESTER DD-111 | differs |
| Displacement declared | 1.88 L | 1.83 L | — |
| Maximum torque declared | 67 lb·ft · 91 N·m | 73 lb·ft · 99 N·m | +9% D-324 Standard |
| Transmission | |||
| Top speed declared | 12.4–15.5 mph · 20–25 km/h | 11.8 mph · 19 km/h | differs |
| Clutch declared | Pedal operated dry Fichtel & Sachs single disc clutch | Pedal operated dry single plate clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 6.5 gpm · 24.5 L/min | — | — |
| Pressure declared | 2,538 psi · 175 bar | — | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 3,770 lb · 1,710 kg | 3,386 lb · 1,536 kg | +11% D 2506 |
| Maximum permissible mass declared | 6,173 lb · 2,800 kg | — | — |
| Wheelbase declared | 73.4 in · 1,865 mm | 70.0 in · 1,779 mm | — |
| Length declared | 131.5 in · 3,340 mm | 108.3 in · 2,750 mm | +21% D 2506 |
| Width declared | 63.0 in · 1,600 mm | 64.6 in · 1,640 mm | — |
| Ground clearance declared | 16.1 in · 410 mm | 15.1 in · 383 mm | +7% D 2506 |
| Turning radius, braked declared | 10.3 ft · 3.15 m | 9.2 ft · 2.80 m | +13% D 2506 |
| Fuel tank declared | — | 31.7 qt · 30.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz (KHD) D 2506 sources
- Source: Traktorenlexikon, “Deutz D 2506”
International Harvester D-324 Standard sources
- Source: Traktorenlexikon, “McCormick D-324 Standard”
- Source: Traktorenlexikon, “McCormick D-324 Farmall”