9 material differences · fewer than 12
Tractor oneDeutz (KHD) D 90061968–1970No measured PTO figureTractor twoInternational Harvester Farmall 8261969–1971No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (Two-wheel or four-wheel drive; 2WD). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
9 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | D 9006 | Farmall 826 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 90.3 hp | 90.8 hp | — |
| Engine declared | KHD F6L 912 | INTERNATIONAL HARVESTER C-301 | differs |
| Displacement declared | 5.65 L | — | — |
| Maximum torque declared | 236 lb·ft · 320 N·m | 251 lb·ft · 340 N·m | +6% Farmall 826 |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6 mph · 30 km/h | — |
| Clutch declared | Dry Walterscheid double clutch operated by two-stage pedal | Pedal-operated dry single-plate clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 9.2 gpm · 34.7 L/min | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 8,058 lb · 3,655 kg | 9,859 lb · 4,472 kg | +22% Farmall 826 |
| Wheelbase declared | 100.4 in · 2,550 mm | 101.2 in · 2,570 mm | — |
| Length declared | 165.7 in · 4,210 mm | 164.0 in · 4,166 mm | — |
| Width declared | 81.7 in · 2,075 mm | 110.0 in · 2,794 mm | +35% Farmall 826 |
| Ground clearance declared | 22.2 in · 565 mm | 24.0 in · 610 mm | +8% Farmall 826 |
| Turning radius, braked declared | 13.1 ft · 4.00 m | 9.8 ft · 2.97 m | +35% D 9006 |
| Fuel tank declared | 126.8 qt · 120 L | 147.9 qt · 140.0 L | +17% Farmall 826 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz (KHD) D 9006 sources
- Source: Traktorenlexikon, “Deutz D 9006”
- Source: Traktorenlexikon, “Deutz-Fahr DX 110”
International Harvester Farmall 826 sources
- Source: Traktorenlexikon, “Farmall Farmall 826”
- Source: Traktorenlexikon, “IHC 806”