7 material differences · fewer than 12
Tractor oneDeutz (KHD) D 62061974–1980No measured PTO figureTractor twoVALMET 702 (A)1972–1980No measured PTO figure
Which should you choose?
Read our verdict on the D 6206 and the 702 (A) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
7 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | D 6206 | 702 (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | — | 70.0 hp | — |
| Engine declared | KHD F4L 912 | VALMET 411 B or C | differs |
| Displacement declared | 3.77 L | 4.18 L | +11% 702 (A) |
| Maximum torque declared | 159 lb·ft · 216 N·m | — | — |
| Transmission | |||
| Top speed declared | 12.4–18.6 mph · 20–30 km/h | 18.6 mph · 30 km/h | differs |
| Clutch declared | Independent two-plate dry clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 7.2 gpm · 27.4 L/min | 6.9 gpm · 26.0 L/min | +5% D 6206 |
| Pressure declared | 2,901 psi · 200 bar | — | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 4,905 lb · 2,225 kg | 7,419–7,606 lb · 3,365–3,450 kg | differs |
| Maximum permissible mass declared | 8,818 lb · 4,000 kg | — | — |
| Wheelbase declared | 83.7 in · 2,125 mm | 88.2 in · 2,240 mm | +5% 702 (A) |
| Length declared | 144.9 in · 3,680 mm | 150.4 in · 3,820 mm | — |
| Width declared | 72.2 in · 1,835 mm | 73.6 in · 1,869 mm | — |
| Ground clearance declared | 18.1 in · 460 mm | 18.1 in · 460 mm | — |
| Turning radius, braked declared | 11.8 ft · 3.61 m | 11.8 ft · 3.61 m | — |
| Fuel tank declared | 63.4 qt · 60 L | — | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz (KHD) D 6206 sources
- Source: Traktorenlexikon, “Deutz D 6006”
- Source: Traktorenlexikon, “Deutz D 6206”
VALMET 702 (A) sources
- Source: Traktorenlexikon, “Valmet 702”