6 material differences · fewer than 12
Tractor oneDeutz (KHD) D 40051965–1967No measured PTO figureTractor twoIMT 5401975–1986No measured PTO figure
Which should you choose?
Read our verdict on the D 4005 and the 540 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
6 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | D 4005 | 540 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 34.3 hp | 39.4 hp | +15% 540 |
| Engine declared | KHD F3L 812/S | IMT-PERKINS M-33/T | differs |
| Displacement declared | 2.55 L | 2.50 L | — |
| Maximum torque declared | 101 lb·ft · 136 N·m | 115 lb·ft · 156 N·m | +15% 540 |
| Transmission | |||
| Top speed declared | 12.4 mph · 20 km/h | 14.9 mph · 24 km/h | +20% 540 |
| Clutch declared | — | Pedal operated dry two-stage FRAD double clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | — | 3.8 gpm · 14.3 L/min | — |
| Pressure declared | 2,538 psi · 175 bar | — | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 3,924 lb · 1,780 kg | 3,946 lb · 1,790 kg | — |
| Maximum permissible mass declared | 7,055 lb · 3,200 kg | — | — |
| Wheelbase declared | 78.5 in · 1,995 mm | 76.8 in · 1,950 mm | — |
| Length declared | 135.0 in · 3,430 mm | 129.9 in · 3,300 mm | — |
| Width declared | 59.6 in · 1,515 mm | 70.9 in · 1,800 mm | +19% 540 |
| Ground clearance declared | 16.3 in · 415 mm | 13.4 in · 340 mm | +22% D 4005 |
| Turning radius, braked declared | 10.7 ft · 3.25 m | 10.7 ft · 3.27 m | — |
| Fuel tank declared | 67.6 qt · 64 L | 52.8 qt · 50.0 L | +28% D 4005 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz (KHD) D 4005 sources
Source
- Source: Traktorenlexikon, “Deutz D 4005”
- Source: Traktorenlexikon, “Kramer KL 350”
IMT 540 sources
Source
- Source: Traktorenlexikon, “IMT 540”