8 material differences · fewer than 12
Tractor oneDEUTZ-ALLIS 60601985–1988No measured PTO figureTractor twoSAME Explorer 65 (DT)1983–1986No measured PTO figure
Which should you choose?
Read our verdict on the 6060 and the Explorer 65 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | 6060 | Explorer 65 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 64.1 hp | 64.1 hp | — |
| Engine declared | ALLIS-CHALMERS 433 T | SAME 916.4 A | differs |
| Displacement declared | 3.29 L | 3.67 L | +12% Explorer 65 (DT) |
| Maximum torque declared | — | 153 lb·ft · 208 N·m | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 18.6 mph · 30 km/h | +20% Explorer 65 (DT) |
| Clutch declared | — | pedal-operated dry single-disc clutch | — |
| Hydraulics & hitch | |||
| Hydraulic control declared | — | Load sensing | — |
| Pump flow declared | 19.0 gpm · 71.9 L/min | 9.6 gpm · 36.5 L/min | +97% 6060 |
| Pressure declared | — | 2,611 psi · 180 bar | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 5,699 lb · 2,585 kg | 5,379 lb · 2,440 kg | +6% 6060 |
| Wheelbase declared | 93.0 in · 2,362 mm | 91.5 in · 2,325 mm | — |
| Length declared | 146.5 in · 3,721 mm | 151.6 in · 3,850 mm | — |
| Width declared | 68.5 in · 1,740 mm | 76.8–96.5 in · 1,950–2,450 mm | differs |
| Ground clearance declared | 20.4 in · 518 mm | 17.9 in · 455 mm | +14% 6060 |
| Turning radius, braked declared | 11.0 ft · 3.34 m | 11.0 ft · 3.35 m | — |
| Fuel tank declared | 127.9 qt · 121.0 L | 70.8 qt · 67.0 L | +81% 6060 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
DEUTZ-ALLIS 6060 sources
- Source: Traktorenlexikon, “Deutz-Allis 6060”
SAME Explorer 65 (DT) sources
- Source: Traktorenlexikon, “SAME Explorer 65”