6 material differences · fewer than 12
Tractor oneClaas Celtis 4262003–2008No measured PTO figureTractor twoFendt Farmer 3071993–1998No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (2003–2008; 1993–1998). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
6 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | Celtis 426 | Farmer 307 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 74 hp | 74 hp | — |
| Engine declared | — | MWM TD 226.B-3 | — |
| Displacement declared | — | 3.12 L | — |
| Maximum torque declared | 209 lb·ft · 283 N·m | 226 lb·ft · 306 N·m | +8% Farmer 307 |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 24.9 mph · 40 km/h | — |
| Clutch declared | — | Single-disc dry clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | 18.2 gpm · 69 L/min | 18.8 gpm · 71.0 L/min | — |
| Pressure declared | 2,611 psi · 180 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/750/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 8,223 lb · 3,730 kg | 8,488 lb · 3,850 kg | — |
| Maximum permissible mass declared | — | 14,330 lb · 6,500 kg | — |
| Wheelbase declared | 98.0 in · 2,489 mm | 84.7 in · 2,152 mm | +16% Celtis 426 |
| Length declared | 149.8 in · 3,805 mm | 153.1 in · 3,890 mm | — |
| Width declared | 98.8 in · 2,510 mm | 83.1 in · 2,110 mm | +19% Celtis 426 |
| Ground clearance declared | 15.0 in · 380 mm | 18.9 in · 480 mm | +26% Farmer 307 |
| Fuel tank declared | 153.2 qt · 145 L | 84.5 qt · 80 L | +81% Celtis 426 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Claas Celtis 426 sources
- Source: Traktorenlexikon, “Claas Celtis 426”
- Source: OECD test report 2219, 2005
Fendt Farmer 307 sources
- Source: Traktorenlexikon, “Fendt Farmer 307”