10 material differences · fewer than 12
Tractor oneCASE-INTERNATIONAL 695 (DT)1990–1993No measured PTO figureTractor twoJohn Deere 5500 (A)1995–1997No measured PTO figure
Which should you choose?
Read our verdict on the 695 (DT) and the 5500 (A) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 695 (DT) | 5500 (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 72.0 hp | 72.0 hp | — |
| Engine declared | IHC D-239 | John Deere 4.029 Turbo | differs |
| Displacement declared | 3.91 L | 3.91 L | — |
| Maximum torque declared | 163 lb·ft · 221 N·m | 199 lb·ft · 270 N·m | +22% 5500 (A) |
| Transmission | |||
| Top speed declared | 21.7 mph · 35 km/h | 18.6 mph · 30 km/h | +17% 695 (DT) |
| Clutch declared | Pedal-operated dry Rockford single-plate clutch designed as driving clutch | Pedal operated dry Carraro single plate clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Open centre | — |
| Pump flow declared | — | 16.5 gpm · 62.5 L/min | — |
| Pressure declared | 2,698 psi · 186 bar | 3,408 psi · 235 bar | +26% 5500 (A) |
| Three-point lift, at the coupling points declared | 5,351 lb · 2,427 kg | 3,803 lb · 1,725 kg | +41% 695 (DT) |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,832 lb · 3,099 kg | 5,672 lb · 2,573 kg | +20% 695 (DT) |
| Wheelbase declared | 88.0 in · 2,235 mm | — | — |
| Length declared | 151.4 in · 3,845 mm | 149.2 in · 3,790 mm | — |
| Width declared | 73.0–92.7 in · 1,854–2,354 mm | 78.8–98.8 in · 2,002–2,510 mm | differs |
| Turning radius, braked declared | — | 11.2 ft · 3.40 m | — |
| Fuel tank declared | 118.3 qt · 112.0 L | 91.9 qt · 87.0 L | +29% 695 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
CASE-INTERNATIONAL 695 (DT) sources
- Source: Traktorenlexikon, “Case-IH 695”
- Source: Traktorenlexikon, “Case-IH 4210”
John Deere 5500 (A) sources
- Source: Traktorenlexikon, “John Deere 5500 (USA)”