9 material differences · fewer than 12
Tractor oneCASE-INTERNATIONAL 4220 (DT)1993–1998No measured PTO figureTractor twoJohn Deere 2555 (A)1984–1992No measured PTO figure
Which should you choose?
Read our verdict on the 4220 (DT) and the 2555 (A) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | 4220 (DT) | 2555 (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 75.9 hp | 76.0 hp | — |
| Engine declared | IHC D-246 | John Deere 4.239 DL-008 or TL-006 | differs |
| Displacement declared | 4.04 L | 3.92 L | — |
| Maximum torque declared | 189 lb·ft · 256 N·m | — | — |
| Transmission | |||
| Top speed declared | 21.7 mph · 35 km/h | 18.6 mph · 30 km/h | +17% 4220 (DT) |
| Clutch declared | Pedal-operated dry Rockford single-disc clutch | Pedal-operated dry LuK single-disc clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Closed centre | — |
| Pump flow declared | 17.2 gpm · 65.0 L/min | — | — |
| Pressure declared | 2,698 psi · 186 bar | 3,336 psi · 230 bar | +24% 2555 (A) |
| Three-point lift, at the coupling points declared | 7,055 lb · 3,200 kg | 3,371 lb · 1,529 kg | +109% 4220 (DT) |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,609 lb · 2,998 kg | 7,110 lb · 3,225 kg | +8% 2555 (A) |
| Wheelbase declared | 88.0 in · 2,235 mm | 89.7 in · 2,279 mm | — |
| Length declared | 147.6 in · 3,749 mm | 145.0 in · 3,683 mm | — |
| Width declared | 73.0–92.7 in · 1,854–2,354 mm | 89.4 in · 2,270 mm | differs |
| Ground clearance declared | — | 16.1 in · 410 mm | — |
| Fuel tank declared | 118.3 qt · 112.0 L | 88.8 qt · 84.0 L | +33% 4220 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
CASE-INTERNATIONAL 4220 (DT) sources
- Source: Traktorenlexikon, “Case-IH 4220”
John Deere 2555 (A) sources
- Source: Traktorenlexikon, “John Deere 2555”