Case-IH MX 120 vs John Deere 7510
11 material differences · fewer than 12
Which should you choose?
We will not advise between these two machines, because their power is not stated as the same quantity on both. The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
11 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | MX 120 | 7510 | Gap |
|---|---|---|---|
| Measured performance | |||
| PTO power, measured measured | 109.6 hp | 115.1 hp | — |
| Drawbar power, measured measured | 95.6 hp | 106.1 hp | +11% 7510 |
| Engine | |||
| Engine power, claimed claimed | 118.4 hp | — | — |
| Engine declared | CDC 6T-590 | John Deere 6.068 TRW-70 | differs |
| Displacement declared | 5.88 L | 6.79 L | +15% 7510 |
| Maximum torque declared | 364 lb·ft · 493 N·m | 395 lb·ft · 535.0 N·m | +9% 7510 |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 18.6–24.9 mph · 30–40 km/h | — |
| Clutch declared | Wet Case-IH multi-plate clutch integrated in the transmission | — | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Closed centre | Closed centre | — |
| Hydraulic control declared | — | Load sensing | — |
| Pump flow declared | 28.8 gpm · 109 L/min | 26.7 gpm · 101.1 L/min | +8% MX 120 |
| Pressure declared | 3,408 psi · 235 bar | 2,538 psi · 175 bar | +34% MX 120 |
| Three-point lift at ends declared | 11,521 lb · 5,226 kg | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 13,812 lb · 6,265 kg | 12,928–13,289 lb · 5,864–6,028 kg | differs |
| Maximum permissible mass declared | 19,842 lb · 9,000 kg | — | — |
| Wheelbase declared | 106.3 in · 2,700 mm | 103.3–111.8 in · 2,625–2,840 mm | — |
| Length declared | 184.1 in · 4,675 mm | 174.6 in · 4,435 mm | +5% MX 120 |
| Width declared | 92.9 in · 2,360 mm | 110.6 in · 2,808 mm | +19% 7510 |
| Height declared | 116.9 in · 2,970 mm | 113.4 in · 2,880 mm | — |
| Ground clearance declared | 15.4 in · 390 mm | 14.2–15.7 in · 360–400 mm | differs |
| Fuel tank declared | 277.9 qt · 263.0 L | 199.7 qt · 189.0 L | +39% MX 120 |
Case-IH MX 120 sources
Source
- Source: OECD test report 1678, 1997
- Source: Traktorenlexikon, “Case-IH MX120”
- Source: OECD test report 1678, 1997
John Deere 7510 sources
Source
- Source: OECD test report 1959, 2001
- Source: Traktorenlexikon, “John Deere 7510”