15 material differences
Tractor oneCase-IH JX902004–200875.0 hpMeasured at the PTO · OECD Test 2636Tractor twoRenault Ceres 3452000–200479.0 hpMeasured at the PTO · OECD Test 1977
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (33%). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
15 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | JX90 | Ceres 345 | Gap |
|---|---|---|---|
| Measured performance | |||
| PTO power, measured measured | 75.0 hp | 79.0 hp | +5% Ceres 345 |
| Drawbar power, measured measured | 60.5 hp | 70.3 hp | +16% Ceres 345 |
| Engine | |||
| Engine declared | TTF 8045.25B.313T | John Deere 4045 TRT 50 | differs |
| Displacement declared | 3.91 L | 4.53 L | +16% Ceres 345 |
| Maximum torque declared | 248 lb·ft · 336.0 N·m | 244 lb·ft · 330.3 N·m | — |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 18.6–24.9 mph · 30–40 km/h | — |
| Clutch declared | dry VALEO double clutch | Dry LuK double clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Hydraulic control declared | Load sensing | Constant flow | differs |
| Pump flow declared | 15.6–16.2 gpm · 59.0–61.5 L/min | 13.5 gpm · 51.1 L/min | differs |
| Pressure declared | 1,450–2,103 psi · 100–145 bar | — | — |
| Rear PTO speeds declared | 540E/540/1000 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,083–9,248 lb · 2,759–4,195 kg | 8,113–8,543 lb · 3,680–3,875 kg | differs |
| Maximum permissible mass declared | 13,228 lb · 6,000 kg | 12,919 lb · 5,860 kg | — |
| Wheelbase declared | 88.5–92.2 in · 2,249–2,342 mm | 95.8–97.2 in · 2,433–2,470 mm | differs |
| Length declared | 152.8–158.7 in · 3,880–4,032 mm | 176.4 in · 4,481 mm | differs |
| Width declared | 71.2–105.7 in · 1,808–2,684 mm | 73.2–92.1 in · 1,860–2,340 mm | differs |
| Ground clearance declared | 13.1–15.4 in · 333–390 mm | 16.5–19.3 in · 420–490 mm | differs |
| Turning radius, braked declared | 12.5–18.4 ft · 3.80–5.60 m | 12.5–13.3 ft · 3.80–4.05 m | differs |
| Fuel tank declared | 97.2–134.2 qt · 92.0–127.0 L | 158.5 qt · 150.0 L | differs |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Case-IH JX90 sources
- Source: OECD test report 2636, 2011
- Source: Traktorenlexikon, “Case-IH JX90”
- Source: Traktorenlexikon, “Case-IH JX90U”
- Source: OECD test report 2637, 2011
Renault Ceres 345 sources
- Source: OECD test report 1977, 2002
- Source: OECD test report 1970, 2001
- Source: Traktorenlexikon, “Renault Ceres 345”
- Source: Traktorenlexikon, “Renault Ceres 345X”