9 material differences · fewer than 12
Tractor oneCase-IH CS-632001–2004No measured PTO figureTractor twoSAME Dorado 65 (DT)2000–2004No measured PTO figure
Which should you choose?
Read our verdict on the CS-63 and the Dorado 65 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | CS-63 | Dorado 65 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 62.2 hp | 62.1 hp | — |
| Engine declared | PERKINS 903-27 T | SAME-DEUTZ-FAHR 1000.3 AT 5 | differs |
| Displacement declared | 2.70 L | 3.00 L | +11% Dorado 65 (DT) |
| Maximum torque declared | 176 lb·ft · 239 N·m | 166 lb·ft · 225 N·m | +6% CS-63 |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 24.9 mph · 40 km/h | differs |
| Clutch declared | Dry double clutch | Pedal-operated, dry S.D.F. single-disc clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 8.1 gpm · 30.8 L/min | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/540E rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 5,490 lb · 2,490 kg | 5,732 lb · 2,600 kg | — |
| Maximum permissible mass declared | — | 11,023 lb · 5,000 kg | — |
| Wheelbase declared | 83.3 in · 2,117 mm | 82.9 in · 2,105 mm | — |
| Length declared | 139.0 in · 3,530 mm | 146.5 in · 3,720 mm | +5% Dorado 65 (DT) |
| Width declared | 74.8 in · 1,900 mm | 75.6–91.3 in · 1,920–2,320 mm | differs |
| Ground clearance declared | — | 17.5 in · 445 mm | — |
| Turning radius, braked declared | — | 10.0 ft · 3.06 m | — |
| Fuel tank declared | 77.1 qt · 73.0 L | 95.1 qt · 90.0 L | +23% Dorado 65 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Case-IH CS-63 sources
- Source: Traktorenlexikon, “Case-IH CS63/a”
- Source: Traktorenlexikon, “Case-IH CS52/a”
SAME Dorado 65 (DT) sources
- Source: Traktorenlexikon, “SAME Dorado 65”