Case-IH 5240 (DT) vs Deutz-Fahr DX 6.30

6 material differences · fewer than 12

Tractor one

1989–1997

No measured PTO figure

Tractor two

1983–1990

No measured PTO figure

Which should you choose?

Read our verdict on the 5240 (DT) and the DX 6.30 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.

6 material differences · 5 fields identical or within 5%, which is not counted as material

Case-IH 5240 (DT) and Deutz-Fahr DX 6.30, field by field
Field	5240 (DT)	DX 6.30	Gap
Engine
Engine power, claimed claimed	106.5 hp	113.7 hp	+7% DX 6.30
Engine declared	CUMMINS NCE 6 T-590	—	—
Displacement declared	5.88 L	—	—
Maximum torque declared	326 lb·ft · 442 N·m	281 lb·ft · 381 N·m	+16% 5240 (DT)
Transmission
Top speed declared	15.5–24.9 mph · 25–40 km/h	18.6–24.9 mph · 30–40 km/h	differs
Hydraulics & hitch
Hydraulic centre declared	—	Open centre	—
Pump flow declared	—	16.0 gpm · 60.4 L/min	—
Pressure declared	—	3,481 psi · 240 bar	—
Three-point lift at ends declared	10,027 lb · 4,548 kg	11,464 lb · 5,200 kg	+14% DX 6.30
Rear PTO speeds declared	540/1000 rpm	540/1000 rpm	—
Weight & dimensions
Unladen weight declared	10,119 lb · 4,590 kg	10,670 lb · 4,840 kg	+5% DX 6.30
Maximum permissible mass declared	—	14,991 lb · 6,800 kg	—
Wheelbase declared	103.7 in · 2,634 mm	106.4 in · 2,703 mm	—
Length declared	172.8 in · 4,390 mm	179.1 in · 4,550 mm	—
Width declared	96.0 in · 2,438 mm	90.7 in · 2,304 mm	+6% 5240 (DT)
Height declared	106.9 in · 2,715 mm	104.3 in · 2,650 mm	—
Ground clearance declared	22.1 in · 561 mm	21.3 in · 540 mm	—
Turning radius, braked declared	—	16.2 ft · 4.94 m	—
Fuel tank declared	179.6 qt · 170.0 L	126.8 qt · 120 L	+42% 5240 (DT)

Source

Source