11 material differences · fewer than 12
Tractor oneCase-IH 385 (DT)1985–1990No measured PTO figureTractor twoFiat 470 (V/DT)1980No measured PTO figure
Which should you choose?
Read our verdict on the 385 (DT) and the 470 (V/DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
11 material differences · 1 fields identical or within 5%, which is not counted as material
| Field | 385 (DT) | 470 (V/DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 45.3 hp | 45.3 hp | — |
| Engine declared | IHC D-155 | FIAT-IVECO 8035.01.320 | differs |
| Displacement declared | 2.54 L | 2.34 L | +8% 385 (DT) |
| Maximum torque declared | 100 lb·ft · 135 N·m | — | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 15.5 mph · 25 km/h | +20% 385 (DT) |
| Clutch declared | Pedal-operated dry Laycock single-plate drive clutch | Pedal-operated two-stage dry FEREDO double clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | — | 5.6 gpm · 21.2 L/min | — |
| Pressure declared | — | 2,843 psi · 196 bar | — |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 5,692 lb · 2,582 kg | 3,120 lb · 1,415 kg | +82% 385 (DT) |
| Wheelbase declared | 79.0 in · 2,007 mm | 73.4 in · 1,865 mm | +8% 385 (DT) |
| Length declared | 139.2 in · 3,535 mm | 124.0 in · 3,150 mm | +12% 385 (DT) |
| Width declared | 72.4–90.6 in · 1,840–2,300 mm | 48.0 in · 1,220 mm | differs |
| Ground clearance declared | 8.5 in · 215 mm | 14.6 in · 370 mm | +72% 470 (V/DT) |
| Fuel tank declared | 80.0 qt · 75.7 L | 57.1 qt · 54.0 L | +40% 385 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Case-IH 385 (DT) sources
- Source: Traktorenlexikon, “Case-IH 385”
- Source: Traktorenlexikon, “Case-IH 3210”
Fiat 470 (V/DT) sources
- Source: Traktorenlexikon, “Fiat 470 V/470 V/DT”
- Source: Traktorenlexikon, “Someca 470 V”