8 material differences · fewer than 12
Tractor oneALLIS-CHALMERS 2001972–1975No measured PTO figureTractor twoFord 50951968–1975No measured PTO figure
Which should you choose?
Read our verdict on the 200 and the 5095 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 200 | 5095 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 93.7 hp | 93.7 hp | — |
| Engine declared | ALLIS-CHALMERS D-2900 | Ford 2704 E | differs |
| Displacement declared | 4.93 L | 5.95 L | +21% 5095 |
| Maximum torque declared | — | 239 lb·ft · 324 N·m | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 15.5 mph · 25 km/h | — |
| Clutch declared | — | Pedal-operated dry single-plate clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 17.2 gpm · 65.1 L/min | 6.0 gpm · 22.7 L/min | +187% 200 |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 8,845 lb · 4,012 kg | 6,614 lb · 3,000 kg | +34% 200 |
| Wheelbase declared | 105.7 in · 2,686 mm | 99.6 in · 2,530 mm | +6% 200 |
| Length declared | 157.5 in · 4,000 mm | 153.5 in · 3,900 mm | — |
| Width declared | 87.6 in · 2,226 mm | 76.8 in · 1,950 mm | +14% 200 |
| Ground clearance declared | 21.4 in · 543 mm | — | — |
| Turning radius, braked declared | 11.1 ft · 3.38 m | 14.6 ft · 4.45 m | +32% 5095 |
| Fuel tank declared | 192.0 qt · 181.7 L | — | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
ALLIS-CHALMERS 200 sources
Source
- Source: Traktorenlexikon, “Allis-Chalmers 200”
- Source: Traktorenlexikon, “Allis-Chalmers 190XT”
Ford 5095 sources
Source
- Source: Traktorenlexikon, “Ford 5095”