12 material differences
Tractor oneAGRIFULL 80-95 Turbo (DT)1980–1986No measured PTO figureTractor twoVALMET 805/805-41983–1989No measured PTO figure
Which should you choose?
Read our verdict on the 80-95 Turbo (DT) and the 805/805-4 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
12 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | 80-95 Turbo (DT) | 805/805-4 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 93.7 hp | 93.7 hp | — |
| Engine declared | V.M.-MOTTORI VM 1054 Turbo | VALMET TD 44 DS 8 | differs |
| Displacement declared | 3.81 L | 4.40 L | +15% 805/805-4 |
| Maximum torque declared | — | 270 lb·ft · 366 N·m | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 18.6 mph · 30 km/h | +20% 805/805-4 |
| Clutch declared | Dry VALEO or LuK double clutch | Pedal-operated dry LuK single-plate clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 7.9 gpm · 30.0 L/min | 13.5 gpm · 51.2 L/min | +71% 805/805-4 |
| Pressure declared | 3,118 psi · 215 bar | 2,901 psi · 200 bar | +8% 80-95 Turbo (DT) |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 7,253 lb · 3,290 kg | 7,804 lb · 3,540 kg | +8% 805/805-4 |
| Wheelbase declared | 98.4 in · 2,500 mm | 93.9 in · 2,385 mm | — |
| Length declared | 150.2 in · 3,815 mm | 177.8 in · 4,515 mm | +18% 805/805-4 |
| Width declared | 80.7–97.2 in · 2,050–2,470 mm | 83.9 in · 2,130 mm | differs |
| Ground clearance declared | 16.9 in · 430 mm | 18.7 in · 475 mm | +10% 805/805-4 |
| Fuel tank declared | 84.5 qt · 80.0 L | 190.2 qt · 180.0 L | +125% 805/805-4 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
AGRIFULL 80-95 Turbo (DT) sources
- Source: Traktorenlexikon, “Agrifull 80-95”
VALMET 805/805-4 sources
- Source: Traktorenlexikon, “Valmet 805”