11 material differences · fewer than 12
Tractor oneAgco RT-952002–2004No measured PTO figureTractor twoLandini 10800 (DT)1987–2000No measured PTO figure
Which should you choose?
Read our verdict on the RT-95 and the 10800 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
11 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | RT-95 | 10800 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 95.6 hp | 95.7 hp | — |
| Engine declared | CUMMINS 6 BT-5.9 | PERKINS TW 6.354-4 | differs |
| Displacement declared | 5.88 L | 5.80 L | — |
| Maximum torque declared | 325 lb·ft · 440 N·m | 245 lb·ft · 332 N·m | +33% RT-95 |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 18.6 mph · 30 km/h | +33% RT-95 |
| Clutch declared | Pedal-operated wet VALEO multi-disc clutch, five discs with 250 mm diameter | pedal-operated dry single-disc clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 29.4 gpm · 111.3 L/min | 13.5 gpm · 51.2 L/min | +117% RT-95 |
| Pressure declared | 3,336 psi · 230 bar | 2,901 psi · 200 bar | +15% RT-95 |
| Three-point lift, at the coupling points declared | 7,361 lb · 3,339 kg | 9,921 lb · 4,500 kg | +35% 10800 (DT) |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 10,399 lb · 4,717 kg | 9,480 lb · 4,300 kg | +10% RT-95 |
| Maximum permissible mass declared | — | 15,432 lb · 7,000 kg | — |
| Wheelbase declared | 107.8 in · 2,739 mm | 106.1 in · 2,696 mm | — |
| Length declared | 173.0 in · 4,394 mm | 175.2 in · 4,450 mm | — |
| Width declared | 113.4 in · 2,880 mm | 83.9 in · 2,130 mm | +35% RT-95 |
| Ground clearance declared | 18.1 in · 460 mm | 16.1 in · 410 mm | +12% RT-95 |
| Fuel tank declared | 169.1 qt · 160.0 L | 200.8 qt · 190.0 L | +19% 10800 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Agco RT-95 sources
- Source: Traktorenlexikon, “AGCO RT 95”
- Source: Traktorenlexikon, “White 6124”
Landini 10800 (DT) sources
- Source: Traktorenlexikon, “Landini 10800 DT”