11 material differences · fewer than 12
Tractor oneAGCO-ALLIS 98151994–1998No measured PTO figureTractor twoDeutz-Fahr DX 2501982–1983No measured PTO figure
Which should you choose?
Read our verdict on the 9815 and the DX 250 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
11 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 9815 | DX 250 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 215.0 hp | 217 hp | — |
| Engine declared | DETROIT-DIESEL DT-530 | KHD BF6L 413 FR | differs |
| Displacement declared | 8.71 L | 9.57 L | +10% DX 250 |
| Maximum torque declared | 729 lb·ft · 989 N·m | 597 lb·ft · 810 N·m | +22% 9815 |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 15.5–18.6 mph · 25–30 km/h | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Closed centre | Open centre | differs |
| Pump flow declared | 27.8 gpm · 105.2 L/min | 21.4 gpm · 81 L/min | +30% 9815 |
| Pressure declared | 2,944 psi · 203 bar | — | — |
| Rear PTO speeds declared | 1000 rpm | 923 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 19,608 lb · 8,894 kg | 20,393 lb · 9,250 kg | — |
| Maximum permissible mass declared | — | 26,455 lb · 12,000 kg | — |
| Wheelbase declared | 115.0 in · 2,921 mm | 118.6 in · 3,012 mm | — |
| Length declared | 200.0 in · 5,080 mm | 213.7 in · 5,427 mm | +7% DX 250 |
| Width declared | 98.0–115.0 in · 2,489–2,921 mm | 98.4 in · 2,500 mm | differs |
| Ground clearance declared | 22.5 in · 572 mm | 20.7 in · 525 mm | +9% 9815 |
| Turning radius, braked declared | 14.8 ft · 4.50 m | — | — |
| Fuel tank declared | 363.5 qt · 344.0 L | 422.7 qt · 400 L | +16% DX 250 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
AGCO-ALLIS 9815 sources
- Source: Traktorenlexikon, “AGCO-Allis 9815”
- Source: Traktorenlexikon, “AGCO-Allis 9675”
Deutz-Fahr DX 250 sources
- Source: Traktorenlexikon, “Deutz-Fahr DX 250”
- Source: Traktorenlexikon, “Deutz-Fahr DX 230”