AGCO-ALLIS 9630 vs John Deere 6910
11 material differences · fewer than 12
Which should you choose?
We will not advise between these two machines, because the drive differs (Two-wheel or four-wheel drive; 4WD); they were not built in overlapping years (1993–1995; 1997–2003). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
11 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | 9630 | 6910 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 133.2 hp | 133.3 hp | — |
| Engine declared | K.H.D. BF6L 913 C | John Deere POWER-TECH 6.068 TLA 52 | differs |
| Displacement declared | 6.13 L | 6.79 L | +11% 6910 |
| Maximum torque declared | 393 lb·ft · 533 N·m | 423 lb·ft · 573 N·m | +8% 6910 |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 18.6–31.1 mph · 30–50 km/h | differs |
| Clutch declared | Hydraulically operated wet Funk multi-disc clutch | Pedal-operated, hydraulic wet Perma-Clutch II designed as a multi-plate clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Closed centre | Closed centre | — |
| Hydraulic control declared | — | Load sensing | — |
| Pump flow declared | 22.6 gpm · 85.6 L/min | — | — |
| Pressure declared | — | 435–3,002 psi · 30–207 bar | — |
| Three-point lift at ends declared | 6,962 lb · 3,158 kg | 16,973 lb · 7,699 kg | +144% 6910 |
| Rear PTO speeds declared | 540/1000 rpm | 540E/540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 14,802 lb · 6,714 kg | 13,503 lb · 6,125 kg | +10% 9630 |
| Maximum permissible mass declared | — | 22,046 lb · 10,000 kg | — |
| Wheelbase declared | 123.2 in · 3,129 mm | 104.3 in · 2,650 mm | +18% 9630 |
| Length declared | 187.5 in · 4,762 mm | 179.6 in · 4,563 mm | — |
| Width declared | 96.0 in · 2,438 mm | 96.1 in · 2,440 mm | — |
| Height declared | 123.5 in · 3,137 mm | 113.7 in · 2,887 mm | +9% 9630 |
| Ground clearance declared | 23.0 in · 584 mm | 18.9 in · 480 mm | +22% 9630 |
| Turning radius, braked declared | 13.8 ft · 4.20 m | — | — |
| Fuel tank declared | 267.9 qt · 253.5 L | 264.2 qt · 250.0 L | — |
AGCO-ALLIS 9630 sources
Source
- Source: Traktorenlexikon, “AGCO-Allis 9630”
John Deere 6910 sources
Source
- Source: Traktorenlexikon, “John Deere 6910”
- Source: OECD test report 1824, 1999