14 material differences

Tractor oneAGCO-ALLIS 56801991–1997No measured PTO figureTractor twoVALMET 6100-41991–1994No measured PTO figure

Which should you choose?

Read our verdict on the 5680 and the 6100-4 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.

Field by field

14 material differences · 4 fields identical or within 5%, which is not counted as material

AGCO-ALLIS 5680 and VALMET 6100-4, field by field
Field56806100-4Gap
Engine
Engine power, claimed claimed78.9 hp77.9 hp—
Engine declaredS.L.H. 1000.4 A-1VALMET 320 DSdiffers
Displacement declared4.00 L3.30 L+21% 5680
Maximum torque declared193 lb·ft · 261 N·m229 lb·ft · 310 N·m+19% 6100-4
Transmission
Top speed declared18.6–24.9 mph · 30–40 km/h18.6–24.9 mph · 30–40 km/h—
Clutch declaredPedal-operated dry SAME double clutchPedal-operated, dry Fichtel & Sachs single-plate clutchdiffers
Hydraulics & hitch
Hydraulic centre declaredOpen centre——
Pump flow declared10.7 gpm · 40.5 L/min21.2 gpm · 80.3 L/min+98% 6100-4
Pressure declared3,046 psi · 210 bar2,031–2,248 psi · 140–155 bardiffers
Three-point lift, at the coupling points declared6,790 lb · 3,080 kg9,601 lb · 4,355 kg+41% 6100-4
Rear PTO speeds declared540/1000 rpm540/1000 rpm—
Weight & dimensions
Unladen weight declared6,669 lb · 3,025 kg8,818 lb · 4,000 kg+32% 6100-4
Maximum permissible mass declared11,464 lb · 5,200 kg13,889 lb · 6,300 kg+21% 6100-4
Wheelbase declared92.9 in · 2,360 mm90.6 in · 2,302 mm—
Length declared154.3 in · 3,919 mm169.1 in · 4,295 mm+10% 6100-4
Width declared76.4–97.0 in · 1,941–2,464 mm85.2 in · 2,165 mmdiffers
Ground clearance declared19.7 in · 500 mm16.1 in · 410 mm+22% 5680
Turning radius, braked declared9.2 ft · 2.80 m13.1 ft · 4.00 m+43% 6100-4
Fuel tank declared83.5 qt · 79.0 L167.0 qt · 158.0 L+100% 6100-4

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

AGCO-ALLIS 5680 sources

Source
  • Source: Traktorenlexikon, “AGCO-Allis 5680”

VALMET 6100-4 sources

Source
  • Source: Traktorenlexikon, “Valmet 6100”
  • Source: Traktorenlexikon, “Valmet 465”