12 material differences
Tractor oneAGCO-ALLIS 56501994–1999No measured PTO figureTractor twoCase-Steyr M 948 (a)1996–2001No measured PTO figure
Which should you choose?
Read our verdict on the 5650 and the M 948 (a) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
12 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 5650 | M 948 (a) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 47.3 hp | 47.3 hp | — |
| Engine declared | S.L.H. 1000.3 A | PERKINS 903-27 | differs |
| Displacement declared | 3.00 L | 2.70 L | +11% 5650 |
| Maximum torque declared | 123 lb·ft · 167 N·m | 155 lb·ft · 210 N·m | +26% M 948 (a) |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Clutch declared | Dry SAME double clutch | Dry Carraro double clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 8.7 gpm · 33.0 L/min | 8.1 gpm · 30.8 L/min | +7% 5650 |
| Pressure declared | 1,305 psi · 90 bar | 3,481 psi · 240 bar | +167% M 948 (a) |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 4,530 lb · 2,055 kg | 5,203 lb · 2,360 kg | +15% M 948 (a) |
| Maximum permissible mass declared | — | 9,259 lb · 4,200 kg | — |
| Wheelbase declared | 77.8 in · 1,976 mm | 83.3 in · 2,117 mm | +7% M 948 (a) |
| Length declared | 133.0 in · 3,378 mm | 139.0 in · 3,530 mm | — |
| Width declared | 66.7–82.5 in · 1,694–2,096 mm | 74.4 in · 1,890 mm | differs |
| Ground clearance declared | 19.7 in · 500 mm | 16.1 in · 410 mm | +22% 5650 |
| Turning radius, braked declared | 8.9 ft · 2.70 m | — | — |
| Fuel tank declared | 60.2 qt · 57.0 L | 77.1 qt · 73.0 L | +28% M 948 (a) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
AGCO-ALLIS 5650 sources
Source
- Source: Traktorenlexikon, “AGCO-Allis 5650”
Case-Steyr M 948 (a) sources
Source
- Source: Traktorenlexikon, “Steyr M 948”