AGCO-ALLIS 5650 or Case-Steyr M 948 (a)?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the 5650 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the M 948 (a) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | 5650 | M 948 (a) | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 35.3 kW (47.3 hp)Traktorenlexikon, “AGCO-Allis 5650” | 35.3 kW (47.3 hp)Traktorenlexikon, “Steyr M 948” | Not comparableNot comparable on power at the PTO shaft: the 5650 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the M 948 (a) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the 5650 and the M 948 (a). |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the 5650 and the M 948 (a). |
| Which pumps more oil for implements? | 33.0 L/min (8.7 gpm)Traktorenlexikon, “AGCO-Allis 5650” | 30.8 L/min (8.1 gpm)Traktorenlexikon, “Steyr M 948” | EvenEven on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which lifts more on the three-point hitch? | 1,888 kg (4,162 lb)Traktorenlexikon, “AGCO-Allis 5650” | 2,220 kg (4,894 lb)Traktorenlexikon, “Steyr M 948” | Not comparableNot comparable on three-point lift: the 5650: lift through the full range 610 mm behind the ends, as stated by the source (Traktorenlexikon, “AGCO-Allis 5650”); the M 948 (a): lift at the hitch ends, as stated by the source (Traktorenlexikon, “Steyr M 948”) — not the same quantity, basis and condition. |
| Which is heavier, for traction? | 2,055 kg (4,530 lb)Traktorenlexikon, “AGCO-Allis 5650” | 2,360 kg (5,203 lb)Traktorenlexikon, “Steyr M 948” | Ahead (a fact, not an advantage)The Case-Steyr M 948 (a) is 15% heavier (305 kg / 672 lb) than the AGCO-ALLIS 5650 (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | — | 4,200 kg (9,259 lb)Traktorenlexikon, “Steyr M 948” | No figureNo call on maximum permissible mass: no figure on record for the 5650. |
| Which has the wider choice of gears? | 12 to 16Traktorenlexikon, “AGCO-Allis 5650” | 16 to 32Traktorenlexikon, “Steyr M 948” | EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the 5650 and the M 948 (a). |
| Which is faster on the road? | 30 km/h (18.6 mph)Traktorenlexikon, “AGCO-Allis 5650” | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Steyr M 948” | EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers more PTO speeds? | 540/1000 rpmTraktorenlexikon, “AGCO-Allis 5650” | 540/1000 rpmTraktorenlexikon, “Steyr M 948” | EvenEven on PTO speeds: the same speeds (540, 1000 rpm). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “AGCO-Allis 5650” | — | No figureNo call on PTO independence: not stated for the M 948 (a). |
| Which drives on both axles? | Two-wheel or four-wheel driveTraktorenlexikon, “AGCO-Allis 5650” | 2WD / 4WDTraktorenlexikon, “Steyr M 948” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 1994–1999 | 1996–2001 | EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Case-Steyr M 948 (a) is 15% heavier (305 kg / 672 lb) than the AGCO-ALLIS 5650 (both unladen weight, as stated by the source).
- Even on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on PTO speeds: the same speeds (540, 1000 rpm).
- Even on drive: every machine is available with four-wheel drive.
- Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
- Not comparable on power at the PTO shaft: the 5650 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the M 948 (a) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- Not comparable on three-point lift: the 5650: lift through the full range 610 mm behind the ends, as stated by the source (Traktorenlexikon, “AGCO-Allis 5650”); the M 948 (a): lift at the hitch ends, as stated by the source (Traktorenlexikon, “Steyr M 948”) — not the same quantity, basis and condition.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, maximum permissible mass, a creeper range and PTO independence.
← Every figure for both machines, side by side, with sources