- Standard layout, Rigid chassis
- WhichTractor size: Utility
- Not independently tested
- 1983–1989
WhichTractor size, not the maker’s category
Derived by WhichTractor from a sourced three-point linkage. How we decide what a machine is
Deutz-Fahr DX 4.50 A Full specifications
KHD BF4L 913 T four-cylinder diesel. The manufacturer claimed 81.0 horsepower. No laboratory has tested one, so there is no measured figure at the shaft.
Engine power, claimed · gross or net not stated
81.0 hp
60.4 kW as stated by the source
Not independently tested
Claimed · standard not stated by the source
Source · Traktorenlexikon, “Deutz-Fahr DX 4.50”, claimed
- Weight
- 8,069 lb
- 3-point lift
- 7,937 lb
- Hyd. flow
- 12.4 gpm
- Top speed
- 18.6–24.9 mph
Deutz-Fahr DX 4.50 A specs: key facts
The Deutz-Fahr DX 4.50 A was built from 1983 to 1989.
The Deutz-Fahr DX 4.50 A has a claimed engine power (gross or net not stated) of 60.4 kW (81.0 hp); it has no measured PTO figure.
The Deutz-Fahr DX 4.50 A was built in two-wheel drive (2WD) and four-wheel drive (4WD) versions, depending on configuration.
The Deutz-Fahr DX 4.50 A has a KHD BF4L 913 T engine, a 4-cylinder 4.09 L diesel unit.
The Deutz-Fahr DX 4.50 A weighs 3,660 kg (8,069 lb) unladen.
The Deutz-Fahr DX 4.50 A has a rear PTO running at 540/1000 rpm.
The three-point hitch of the Deutz-Fahr DX 4.50 A lifts 3,600 kg (7,937 lb) at the lower-link ends.
The hydraulic pump of the Deutz-Fahr DX 4.50 A delivers 47.0 L/min (12.4 gpm).
Source · Traktorenlexikon, “Deutz-Fahr DX 4.50”
How much horsepower does a DX 4.50 A have?
The only figure for the DX 4.50 A is 81.0 hp (60.4 kW) of claimed engine power, gross or net not stated, no test standard stated — not power at the shaft.
Source · Traktorenlexikon, “Deutz-Fahr DX 4.50”
What engine is in a DX 4.50 A?
A DX 4.50 A has a KHD BF4L 913 T, a 4-cylinder 4.09 L diesel engine.
| Make & model | KHD BF4L 913 T |
|---|---|
| Cylinders | 4, air-cooled |
| Displacement | 249.3 ci · 4.09 L |
| Max torque | 211 lb·ft · 286 N·m @ 1,601 rpm |
| Injection | Bosch multi-hole nozzle, swirl injection channel |
| Electrical system | 12 V |
Source · Traktorenlexikon, “Deutz-Fahr DX 4.50”
How much will a DX 4.50 A lift, and what is its hydraulic flow?
A DX 4.50 A lifts 7,937 lb (3,600 kg) at the lower-link ends.
| System | Open centre |
|---|---|
| Pump flow | 12.4 gpm · 47.0 L/min |
| Pressure | 3,481 psi · 240 bar |
| Lift at ends | 7,937 lb · 3,600 kg |
| Rear PTO | 540/1000 rpm @ 2,192 engine rpm |
Source · Traktorenlexikon, “Deutz-Fahr DX 4.50”
What transmission does a DX 4.50 A have?
Transmission specifications for the DX 4.50 A are below.
| Clutch | Independent dry double clutch |
|---|---|
| Steering | Hydrostatic Danfoss steering |
| Top speed | 18.6–24.9 mph · 30–40 km/hthe article lists alternatives |
Source · Traktorenlexikon, “Deutz-Fahr DX 4.50”
How much does a DX 4.50 A weigh?
A DX 4.50 A weighs 8,069 lb (3,660 kg) unladen.
| Unladen weight | 8,069 lb · 3,660 kgtwo-wheel-drive version |
|---|---|
| Maximum permissible mass | 12,125 lb · 5,500 kg |
| Maximum front axle load | 4,255 lb · 1,930 kg |
| Maximum rear axle load | 9,259 lb · 4,200 kg |
| Wheelbase | 91.9 in · 2,333 mmtwo-wheel-drive version |
| Length | 159.1 in · 4,040 mmtwo-wheel-drive version |
| Width | 90.7 in · 2,304 mm |
| Height | 102.8 in · 2,610 mm |
| Ground clearance | 20.9 in · 530 mmtwo-wheel-drive version |
| Front track | 55.1–74.8 in · 1,400–1,900 mmtwo-wheel-drive version |
| Rear track | 65.0 in · 1,650 mm |
Source · Traktorenlexikon, “Deutz-Fahr DX 4.50”
Which tractors compare with a DX 4.50 A?
Within 10% of its 72.0 hp at the PTO (claimed), the same type, and first built within 15 years of it.
- CASE-INTERNATIONAL 895 (DT)72.0 hp PTO, claimed · 1990–1993Side by side with the DX 4.50 A →
- Massey Ferguson MF 4245 (A)72.0 hp PTO, claimed · 1997–2001Side by side with the DX 4.50 A →
- Renault 80-14 TX71.9 hp PTO, claimed · 1984–1987Side by side with the DX 4.50 A →
- Renault 85-14 LS71.9 hp PTO, claimed · 1985–1989Side by side with the DX 4.50 A →
- Renault 85-34 MX71.9 hp PTO, claimed · 1989–1993Side by side with the DX 4.50 A →
- VOLVO-BM T 70071.9 hp PTO, claimed · 1976–1982Side by side with the DX 4.50 A →
Everything else people ask
Is a DX 4.50 A two-wheel drive or four-wheel drive?
The Deutz-Fahr DX 4.50 A was built in two-wheel drive (2WD) and four-wheel drive (4WD) versions, depending on configuration.
What PTO does a DX 4.50 A have?
A DX 4.50 A has a 540/1000 rpm rear PTO.
Where this page comes from
Compiled from Traktorenlexikon, “Deutz-Fahr DX 4.50”.
Sources
Facts taken from these documents, units converted. Numbers beside a figure refer to this list. Licences and attribution
- Traktorenlexikon: Deutz-Fahr DX 4.50 — CC BY-SA 4.0, WIKIBOOKS-TL-68250 · revision 1089898. Wikibooks contributors (Traktorenlexikon). Original document