WhichTractor
  • Rigid chassis
  • WhichTractor size: Utility
  • Not independently tested
  • 2007–2008

It was ranked on an engine power figure whose source does not say gross or net. WhichTractor size, not the maker’s category

Derived by WhichTractor from a sourced three-point linkage. How we decide what a machine is

Deutz-Fahr Agrofarm 100 Full specifications

The manufacturer claimed 88.8 horsepower. No laboratory has tested one, so there is no measured figure at the shaft.

Engine power, claimed · gross or net not stated

88.8 hp

66.2 kW as stated by the source

Not independently tested

Claimed · standard not stated by the source

Source · Traktorenlexikon, “Deutz-Fahr Agrofarm 100”, claimed

Weight
9,480 lb
3-point lift
10,582 lb
Hyd. flow
14.7 gpm
Top speed
24.9 mph

Deutz-Fahr Agrofarm 100 specs: key facts

  • The Deutz-Fahr Agrofarm 100 was built from 2007 to 2008.

  • The Deutz-Fahr Agrofarm 100 has a claimed engine power (gross or net not stated) of 66.2 kW (88.8 hp); it has no measured PTO figure.

  • The Deutz-Fahr Agrofarm 100 is four-wheel drive (4WD).

  • The Deutz-Fahr Agrofarm 100 weighs 4,300 kg (9,480 lb) unladen.

  • The Deutz-Fahr Agrofarm 100 has an independent rear PTO running at 540 rpm / 1000 rpm.

  • The three-point hitch of the Deutz-Fahr Agrofarm 100 lifts 4,800 kg (10,582 lb) at the lower-link ends.

  • The hydraulic pump of the Deutz-Fahr Agrofarm 100 delivers 55.5 L/min (14.7 gpm).

Source · Traktorenlexikon, “Deutz-Fahr Agrofarm 100”

How much horsepower does an Agrofarm 100 have?

The only figure for the Agrofarm 100 is 88.8 hp (66.2 kW) of claimed engine power, gross or net not stated, no test standard stated — not power at the shaft.

Engine, claimed (gross/net not stated)
88.8 hp

Source · Traktorenlexikon, “Deutz-Fahr Agrofarm 100”

How much will an Agrofarm 100 lift, and what is its hydraulic flow?

An Agrofarm 100 lifts 10,582 lb (4,800 kg) at the lower-link ends.

Hydraulics & PTO — Agrofarm 100 hydraulics and PTO specifications
SystemOpen centre
Pump flow14.7 gpm · 55.5 L/min
Lift at ends10,582 lb · 4,800 kg
Rear PTOIndependent, engine-driven, 540 rpm / 1000 rpm @ 2,083 engine rpmEngages under load

Source · Traktorenlexikon, “Deutz-Fahr Agrofarm 100”

What transmission does an Agrofarm 100 have?

Transmission specifications for the Agrofarm 100 are below.

Transmission — Agrofarm 100 transmission specifications
ClutchPedal operated dry single clutch
SteeringHydrostatic Danfoss steering
Top speed24.9 mph · 40 km/h

Source · Traktorenlexikon, “Deutz-Fahr Agrofarm 100”

How much does an Agrofarm 100 weigh?

An Agrofarm 100 weighs 9,480 lb (4,300 kg) unladen.

Weights & dimensions — Agrofarm 100 weights and dimensions
Unladen weight9,480 lb · 4,300 kg
Maximum permissible mass15,873 lb · 7,200 kg
Maximum front axle load6,614 lb · 3,000 kg
Maximum rear axle load10,582 lb · 4,800 kg
Wheelbase92.1 in · 2,340 mm
Length155.5 in · 3,950 mm
Width86.8 in · 2,204 mm
Height103.9 in · 2,638 mm
Ground clearance19.7 in · 500 mm
Front track60.4–84.2 in · 1,534–2,138 mm
Rear track65.0–80.8 in · 1,652–2,052 mm

Source · Traktorenlexikon, “Deutz-Fahr Agrofarm 100”

Which tractors compare with an Agrofarm 100?

Within 10% of its 88.8 hp of claimed engine power, the same type, and first built within 15 years of it.

Everything else people ask

Is an Agrofarm 100 two-wheel drive or four-wheel drive?

The Deutz-Fahr Agrofarm 100 is four-wheel drive (4WD).

What PTO does an Agrofarm 100 have?

An Agrofarm 100 has a independent 540 rpm / 1000 rpm rear PTO.

Where this page comes from

Compiled from Traktorenlexikon, “Deutz-Fahr Agrofarm 100”.

Last verified

Not yet verified

Spotted an error?

Sources

Facts taken from these documents, units converted. Numbers beside a figure refer to this list. Licences and attribution

  1. Traktorenlexikon: Deutz-Fahr Agrofarm 100 — CC BY-SA 4.0, WIKIBOOKS-TL-89904 · revision 956344. Wikibooks contributors (Traktorenlexikon). Original document