A version of the Case-IH MX 100 · 1997–2002
Case-IH MX 100 C
How does the MX 100 C differ?
The MX 100 C has the PERKINS-FASTRAM 1004-4 Turbo-HR engine; the 5 other versions on record are set out beside it. Shared figures are on the model page.
What else is on record for the MX 100 C?
| Forward gears | 16 |
|---|---|
| Reverse gears | 12 |
| Transmission as described | 16 forward/12 reverse and 32 forward/24 reverse |
| Cooling | Liquid-cooled |
| Clutch | Pedal-operated wet multi-plate driving clutch |
| Hydraulic centre | Closed centreSource 2 |
| Wheelbase | 95.4 in · 2,422 mm |
| Weight, unballasted | 11,773 lb · 5,340 kg |
| Fuel tank | 199.7 qt · 189.0 L |
| Front tyre, standard | 14.9 R 28 AS |
| System voltage | 12 V |
| Operator enclosure | Cab |
| Roll-over protection (ROPS) | Yes |
| Fuel injection | direct injection |
| Top speed forward | 24.9 mph · 40 km/h |
| Pump flow | 22.8 gpm · 86.4 L/min |
| Length | 183.1 in · 4,650 mm |
| Rear tyre, standard | 18.4 R 38 AS |
| Alternator or generator output | 95 A |
| Top speed reverse | 13.7 mph · 22.03 km/h |
| Construction | block construction (frameless) |
| Maximum torque | 260 lb·ft · 352 N·m |
| Hydraulic pressure | 3,408 psi · 235 bar |
| Width | 90.6 in · 2,300 mm |
| Battery | 12 V-95 Ah |
| Maximum torque speed | 1,398 rpm |
| Air cleaner | Donaldson dry air filter with cyclone pre-separator |
| Service brakes | Pedal-operated hydraulic wet full-disc brake acting on differential side shafts |
| Rear PTO drive | Engine-driven |
| Rear remote valves | 3 |
| Height to top | 112.4 in · 2,855 mm |
| Maximum permissible mass | 16,535 lb · 7,500 kg |
| Rear PTO independence | Independent |
| PTO engages under load | Yes |
| Cylinders | 4 |
| Steering | Hydrostatic Rexroth steering |
| Three-point hitch category | Category 2 |
| Ground clearance | 15.2 in · 385 mm |
| Maximum front axle load | 7,275 lb · 3,300 kg |
| Displacement | 4.2 qt · 4.0 L |
| Maximum rear axle load | 11,618 lb · 5,270 kg |
| Bore | 3.9 in · 100 mm |
| Stroke | 5.0 in · 127 mm |
| Rated engine speed | 2,200 rpm |
| Torque rise | 24 % |
| Differential lock | Electro-hydraulically operated multi-plate differential lock |
| Front track | 60.2–87.8 in · 1,530–2,230 mm |
| Rear track | 64.2–87.8 in · 1,630–2,230 mm |
| Turning radius without brakes | 16.4 ft · 4.99 m |
| Rear PTO speeds | 540/1000 rpm |
| Engine speed at 540 PTO | 1,875 rpm |
| Rear PTO shaft | 35 mm, 6 splines / 35 mm, 21 splinesSource 2 |
| Engine power, gross or net not stated, claimed, standard not stated by the source | 101 hp · 75 kW |
| PTO power, claimed, standard not stated by the source | 82.3 hp · 61.4 kW |
| Drive | 4WD |
Source · Traktorenlexikon, “Case-IH MX100C”
Sources
Facts taken from these documents, units converted. Numbers beside a figure refer to this list. Licences and attribution
- OECD Code 2 test report 1 678/1: Case IH MX 120 — Licence not stated by the publisher; facts cited, OECD-1678 · published 1997-10-02 · retrieved 2026-09-14. OECD; testing station DLG, Gross-Umstadt, Germany. Original document
- OECD Code 2 test report 1/1 939: Case IH MX 100C — Licence not stated by the publisher; facts cited, OECD-1939 · published 2000-11-08 · retrieved 2026-09-14. OECD; testing station DLG, Gross-Umstadt, Germany. Original document
- OECD Code 2 test report 2/1 896: Case IH CX 80 — Licence not stated by the publisher; facts cited, OECD-1896 · published 2000-03-22 · retrieved 2026-09-14. OECD; testing station DLG, Gross-Umstadt, Germany. Original document
- Traktorenlexikon: Case-IH MX100C — CC BY-SA 4.0, WIKIBOOKS-TL-115631 · revision 1044802. Wikibooks contributors (Traktorenlexikon). Original document
- Traktorenlexikon: Case-IH MX135 — CC BY-SA 4.0, WIKIBOOKS-TL-29103 · revision 1010867. Wikibooks contributors (Traktorenlexikon). Original document