5 material differences · fewer than 12
Tractor oneVALMET 405 (405/4)1985–1989No measured PTO figureTractor twoVALMET 604 / 604-41982–1985No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (Two-wheel or four-wheel drive; 2WD). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
5 material differences · 8 fields identical or within 5%, which is not counted as material
| Field | 405 (405/4) | 604 / 604-4 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 60.2 hp | 60.2 hp | — |
| Engine declared | VALMET TD-27 DS 4 | VALMET D 33 C | differs |
| Displacement declared | 2.69 L | 3.30 L | +23% 604 / 604-4 |
| Maximum torque declared | 149 lb·ft · 202 N·m | 162 lb·ft · 220 N·m | +9% 604 / 604-4 |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6 mph · 30 km/h | — |
| Clutch declared | — | Dry Fichtel & Sachs double clutch, type 11"/11" | — |
| Hydraulics & hitch | |||
| Pump flow declared | 9.7 gpm · 36.6 L/min | 10.0 gpm · 38.0 L/min | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 5,975 lb · 2,710 kg | 6,173 lb · 2,800 kg | — |
| Wheelbase declared | 83.1 in · 2,112 mm | 83.1 in · 2,112 mm | — |
| Length declared | 146.1 in · 3,710 mm | 142.4 in · 3,617 mm | — |
| Width declared | 76.3 in · 1,938 mm | 76.0 in · 1,930 mm | — |
| Ground clearance declared | 19.9 in · 505 mm | 18.5 in · 470 mm | +7% 405 (405/4) |
| Turning radius, braked declared | — | 11.5 ft · 3.50 m | — |
| Fuel tank declared | 77.1 qt · 73.0 L | 68.7 qt · 65.0 L | +12% 405 (405/4) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
VALMET 405 (405/4) sources
- Source: Traktorenlexikon, “Valmet 405”
VALMET 604 / 604-4 sources
- Source: Traktorenlexikon, “Valmet 604”