10 material differences · fewer than 12

Tractor oneVALMET 365 (365-4)1994–1997No measured PTO figureTractor twoZETOR 4320/43401993–1997No measured PTO figure

Which should you choose?

Read our verdict on the 365 (365-4) and the 4320/4340 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.

Field by field

10 material differences · 7 fields identical or within 5%, which is not counted as material

VALMET 365 (365-4) and ZETOR 4320/4340, field by field
Field365 (365-4)4320/4340Gap
Engine
Engine power, claimed claimed60.2 hp60.2 hp—
Engine declaredVALMET 320 DZBROJORKA Z-6201differs
Displacement declared3.30 L3.46 L—
Maximum torque declared162 lb·ft · 220 N·m148 lb·ft · 201 N·m+9% 365 (365-4)
Transmission
Top speed declared18.6–24.9 mph · 30–40 km/h15.5–18.6 mph · 25–30 km/hdiffers
Clutch declaredDry FICHTEL & SACHS double clutchDry Zbrojovka double clutchdiffers
Hydraulics & hitch
Hydraulic centre declaredOpen centre——
Pump flow declared14.5 gpm · 55.0 L/min8.4 gpm · 31.8 L/min+73% 365 (365-4)
Pressure declared2,901 psi · 200 bar1,160 psi · 80 bar+150% 365 (365-4)
Three-point lift, at the coupling points declared5,688 lb · 2,580 kg5,849 lb · 2,653 kg—
Rear PTO speeds declared540E/540 rpm540/1000 rpmdiffers
Weight & dimensions
Unladen weight declared6,217 lb · 2,820 kg6,349 lb · 2,880 kg—
Maximum permissible mass declared—12,346 lb · 5,600 kg—
Wheelbase declared83.1 in · 2,112 mm88.9 in · 2,257 mm+7% 4320/4340
Length declared146.1 in · 3,710 mm142.9 in · 3,630 mm—
Width declared79.9 in · 2,030 mm73.0 in · 1,854 mm+9% 365 (365-4)
Ground clearance declared15.9 in · 405 mm19.4 in · 492 mm+21% 4320/4340
Turning radius, braked declared11.5 ft · 3.50 m11.8 ft · 3.60 m—
Fuel tank declared77.1 qt · 73.0 L74.0 qt · 70.0 L—

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

VALMET 365 (365-4) sources

Source
  • Source: Traktorenlexikon, “Valmet 365”
  • Source: Traktorenlexikon, “Valmet 255”

ZETOR 4320/4340 sources

Source
  • Source: Traktorenlexikon, “Zetor 4320/4340”
  • Source: Traktorenlexikon, “Zetor 6211”