11 material differences · fewer than 12
Tractor oneVALMET 361 D1960–1965No measured PTO figureTractor twoZETOR 35 Super1955–1960No measured PTO figure
Which should you choose?
Read our verdict on the 361 D and the 35 Super → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
11 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | 361 D | 35 Super | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 41.4 hp | 41.4 hp | — |
| Engine declared | VALMET 310 D or 310 A | — | — |
| Displacement declared | 2.69 L | — | — |
| Maximum torque declared | 116 lb·ft · 157 N·m | 164 lb·ft · 222 N·m | +41% 35 Super |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 15.5 mph · 25 km/h | +20% 361 D |
| Clutch declared | Pedal operated dry single plate clutch | pedal-operated dry single-disc clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 5.8 gpm · 22.0 L/min | 3.3 gpm · 12.5 L/min | +76% 361 D |
| Pressure declared | — | 1,707 psi · 118 bar | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 3,902 lb · 1,770 kg | 6,305 lb · 2,860 kg | +62% 35 Super |
| Wheelbase declared | 74.6 in · 1,895 mm | 86.2 in · 2,190 mm | +16% 35 Super |
| Length declared | 114.6 in · 2,910 mm | 132.3 in · 3,360 mm | +15% 35 Super |
| Width declared | 67.9–88.2 in · 1,725–2,240 mm | 73.8 in · 1,875 mm | differs |
| Ground clearance declared | 17.7 in · 450 mm | 20.7 in · 525 mm | +17% 35 Super |
| Turning radius, braked declared | 10.0 ft · 3.04 m | 12.5 ft · 3.82 m | +26% 35 Super |
| Fuel tank declared | 40.2 qt · 38.0 L | 68.7 qt · 65.0 L | +71% 35 Super |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
VALMET 361 D sources
- Source: Traktorenlexikon, “Valmet 361 D”
ZETOR 35 Super sources
- Source: Traktorenlexikon, “Zetor 35 Super”