8 material differences · fewer than 12
Tractor oneVALMET 355 (355/4)1990–1994No measured PTO figureTractor twoVALMET 604 / 604-41982–1985No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (Two-wheel or four-wheel drive; 2WD); they were not built in overlapping years (1990–1994; 1982–1985). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
8 material differences · 7 fields identical or within 5%, which is not counted as material
| Field | 355 (355/4) | 604 / 604-4 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 60.2 hp | 60.2 hp | — |
| Engine declared | VALMET TD-33 D 3 or 320 D | VALMET D 33 C | differs |
| Displacement declared | 3.30 L | 3.30 L | — |
| Maximum torque declared | 146 lb·ft · 198 N·m | 162 lb·ft · 220 N·m | +11% 604 / 604-4 |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 18.6 mph · 30 km/h | +20% 604 / 604-4 |
| Clutch declared | — | Dry Fichtel & Sachs double clutch, type 11"/11" | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 8.2 gpm · 31.0 L/min | 10.0 gpm · 38.0 L/min | +23% 604 / 604-4 |
| Pressure declared | 4,206 psi · 290 bar | — | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 5,886 lb · 2,670 kg | 6,173 lb · 2,800 kg | — |
| Wheelbase declared | 83.1 in · 2,112 mm | 83.1 in · 2,112 mm | — |
| Length declared | 146.1 in · 3,710 mm | 142.4 in · 3,617 mm | — |
| Width declared | 77.4–97.8 in · 1,965–2,485 mm | 76.0 in · 1,930 mm | differs |
| Height, over the cab declared | 96.9 in · 2,460 mm | 100.2 in · 2,545 mm | — |
| Ground clearance declared | 15.9 in · 405 mm | 18.5 in · 470 mm | +16% 604 / 604-4 |
| Turning radius, braked declared | 10.2 ft · 3.10 m | 11.5 ft · 3.50 m | +13% 604 / 604-4 |
| Fuel tank declared | 77.1 qt · 73.0 L | 68.7 qt · 65.0 L | +12% 355 (355/4) |
VALMET 355 (355/4) sources
Source
- Source: Traktorenlexikon, “Valmet 355”
VALMET 604 / 604-4 sources
Source
- Source: Traktorenlexikon, “Valmet 604”