9 material differences · fewer than 12
Tractor oneUTB U-1033 (DT)1994–2004No measured PTO figureTractor twoVALMET 6600-4 (6600E)1991–2000No measured PTO figure
Which should you choose?
Read our verdict on the U-1033 (DT) and the 6600-4 (6600E) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | U-1033 (DT) | 6600-4 (6600E) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 103.5 hp | 103.5 hp | — |
| Engine declared | UTB 261.073 | VALMET 420 DS (420 DSE) | differs |
| Displacement declared | 5.64 L | 4.40 L | +28% U-1033 (DT) |
| Maximum torque declared | 271 lb·ft · 368 N·m | 299 lb·ft · 405 N·m | +10% 6600-4 (6600E) |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 18.6–31.1 mph · 30–50 km/h | differs |
| Clutch declared | dry U.T.B. double clutch | Pedal operated dry Fichtel & Sachs single plate clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | — | 21.2 gpm · 80.3 L/min | — |
| Pressure declared | 2,031 psi · 140 bar | 2,031–2,248 psi · 140–155 bar | differs |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 9,700 lb · 4,400 kg | 9,700 lb · 4,400 kg | — |
| Maximum permissible mass declared | — | 16,535 lb · 7,500 kg | — |
| Wheelbase declared | 100.4 in · 2,550 mm | 91.6 in · 2,326 mm | +10% U-1033 (DT) |
| Length declared | 172.8 in · 4,390 mm | 177.7 in · 4,514 mm | — |
| Width declared | 76.3 in · 1,939 mm | 78.1–101.8 in · 1,985–2,585 mm | differs |
| Ground clearance declared | 13.8 in · 350 mm | 19.1 in · 485 mm | +39% 6600-4 (6600E) |
| Turning radius, braked declared | 14.8 ft · 4.50 m | 15.3 ft · 4.65 m | — |
| Fuel tank declared | 169.1 qt · 160.0 L | 174.4 qt · 165.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
UTB U-1033 (DT) sources
- Source: Traktorenlexikon, “UTB U 1033 DT”
VALMET 6600-4 (6600E) sources
- Source: Traktorenlexikon, “Valmet 6600”