SOMECA DA-50 or Steyr 288?
Which should you choose?
On performance, every comparable figure that differs favours the Steyr 288: hydraulic flow and three-point lift. It is also ahead on forward gears, top speed and PTO speeds.
- The Steyr 288 suits PTO-driven implements (mowers, balers, pumps) better on this data: offers 1000 rpm.
- The Steyr 288 suits loader and hydraulic implement work better on this data: 248% (22.8 L/min / 6.0 gpm) more hydraulic flow and 100% (800 kg / 1,764 lb) more three-point lift.
- The Steyr 288 suits road haulage better on this data: 36% (8.0 km/h / 5.0 mph) more top speed.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | DA-50 | 288 | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 29.1 kW (39.0 hp)Traktorenlexikon, “Someca DA 50” | 29.4 kW (39 hp)Traktorenlexikon, “Steyr 288” | EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the DA-50 and the 288. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the DA-50 and the 288. |
| Which pumps more oil for implements? | 9.2 L/min (2.4 gpm)Traktorenlexikon, “Someca DA 50” | 32.0 L/min (8.5 gpm)Traktorenlexikon, “Steyr 288” | AheadThe Steyr 288 has 248% more hydraulic flow (22.8 L/min / 6.0 gpm) than the SOMECA DA-50 (both pump flow, as stated by the source). |
| Which lifts more on the three-point hitch? | 800 kg (1,764 lb)Traktorenlexikon, “Someca DA 50” | 1,600 kg (3,527 lb)Traktorenlexikon, “Steyr 288” | AheadThe Steyr 288 has 100% more lift (800 kg / 1,764 lb) than the SOMECA DA-50 (both lift at the hitch ends, as stated by the source). |
| Which is heavier, for traction? | 2,080 kg (4,586 lb)Traktorenlexikon, “Someca DA 50” | 1,930 kg (4,255 lb)Traktorenlexikon, “Steyr 288” | EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which may carry more ballast and load? | — | — | No figureNo call on maximum permissible mass: no figure on record for the DA-50 and the 288. |
| Which has the wider choice of gears? | 5Traktorenlexikon, “Someca DA 50” | 8 to 12Traktorenlexikon, “Steyr 288” | AheadThe Steyr 288 has 60% more forward gears (3 gears) than the SOMECA DA-50 (both forward gears, as stated by the source). |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the DA-50 and the 288. |
| Which is faster on the road? | 22 km/h (13.7 mph)Traktorenlexikon, “Someca DA 50” | 30 km/h (18.6 mph)Traktorenlexikon, “Steyr 288” | AheadThe Steyr 288 has 36% more top speed (8.0 km/h / 5.0 mph) than the SOMECA DA-50 (both top speed forward, as stated by the source). |
| Which offers more PTO speeds? | 540 rpmTraktorenlexikon, “Someca DA 50” | 540/1000 rpmTraktorenlexikon, “Steyr 288” | AheadThe Steyr 288 offers 1000 rpm at the PTO, which the SOMECA DA-50 does not (as stated by the sources). |
| Which PTO runs independently of the ground drive? | dependent (stops with the clutch)Traktorenlexikon, “Someca DA 50” | — | No figureNo call on PTO independence: not stated for the 288. |
| Which drives on both axles? | 2WDTraktorenlexikon, “Someca DA 50” | 2WDTraktorenlexikon, “Steyr 288” | EvenEven on drive: all two-wheel drive. |
| Which is newer, and what about parts? | 1952–1955 | 1962–1966 | Ahead (a fact, not an advantage)The Steyr 288 is newer: production began 10 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Steyr 288 has 248% more hydraulic flow (22.8 L/min / 6.0 gpm) than the SOMECA DA-50 (both pump flow, as stated by the source).
- The Steyr 288 has 100% more lift (800 kg / 1,764 lb) than the SOMECA DA-50 (both lift at the hitch ends, as stated by the source).
- The Steyr 288 has 60% more forward gears (3 gears) than the SOMECA DA-50 (both forward gears, as stated by the source).
- The Steyr 288 has 36% more top speed (8.0 km/h / 5.0 mph) than the SOMECA DA-50 (both top speed forward, as stated by the source).
- The Steyr 288 offers 1000 rpm at the PTO, which the SOMECA DA-50 does not (as stated by the sources).
- The Steyr 288 is newer: production began 10 years later. We hold no parts-availability data, so there is no call on parts.
- Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
- Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on drive: all two-wheel drive.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, maximum permissible mass, a creeper range and PTO independence.
← Every figure for both machines, side by side, with sources