SOMECA 300 (TD) or URSUS C-328?

Which should you choose?

The data can’t decide this. Power at the PTO shaft cannot be compared: the 300 (TD) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the C-328 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.

  • The URSUS C-328 suits loader and hydraulic implement work better on this data: 94% (8.7 L/min / 2.3 gpm) more hydraulic flow.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for SOMECA 300 (TD) and URSUS C-328, with the call on each
Question300 (TD)C-328Call
Which puts more power through the PTO shaft?20.6 kW (27.6 hp)Traktorenlexikon, “Someca 300”20.6 kW (27.6 hp)Traktorenlexikon, “Ursus C-328”Not comparableNot comparable on power at the PTO shaft: the 300 (TD) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the C-328 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the 300 (TD) and the C-328.
Which pulls harder at the drawbar?No figureNo call on drawbar power: no figure on record for the 300 (TD) and the C-328.
Which pumps more oil for implements?9.3 L/min (2.5 gpm)Traktorenlexikon, “Someca 300”18.0 L/min (4.8 gpm)Traktorenlexikon, “Ursus C-328”AheadThe URSUS C-328 has 94% more hydraulic flow (8.7 L/min / 2.3 gpm) than the SOMECA 300 (TD) (both pump flow, as stated by the source).
Which lifts more on the three-point hitch?650 kg (1,433 lb)Traktorenlexikon, “Someca 300”700 kg (1,543 lb)Traktorenlexikon, “Ursus C-328”EvenEven on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call.
Which is heavier, for traction?1,080 kg (2,381 lb)Traktorenlexikon, “Someca 300”1,654 kg (3,646 lb)Traktorenlexikon, “Ursus C-328”Ahead (a fact, not an advantage)The URSUS C-328 is 53% heavier (574 kg / 1,265 lb) than the SOMECA 300 (TD) (both unladen weight, as stated by the source).
Which may carry more ballast and load?No figureNo call on maximum permissible mass: no figure on record for the 300 (TD) and the C-328.
Which has the wider choice of gears?6Traktorenlexikon, “Someca 300”6Wikipedia (pl): Ursus C-328 (open data)EvenEven on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
Which offers a creeper range?No figureNo call on a creeper range: not stated for the 300 (TD) and the C-328.
Which is faster on the road?25 km/h (15.5 mph)Traktorenlexikon, “Someca 300”23 km/h (14.3 mph)Traktorenlexikon, “Ursus C-328”EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
Which offers more PTO speeds?540 rpmTraktorenlexikon, “Someca 300”540 rpmTraktorenlexikon, “Ursus C-328”EvenEven on PTO speeds: the same speeds (540 rpm).
Which PTO runs independently of the ground drive?dependent (stops with the clutch)Traktorenlexikon, “Someca 300”independentTraktorenlexikon, “Ursus C-328”AheadThe URSUS C-328 has an independent PTO; the SOMECA 300 (TD)’s is dependent (stops with the clutch).
Which drives on both axles?Two-wheel or four-wheel driveTraktorenlexikon, “Someca 300”2WDTraktorenlexikon, “Ursus C-328”AheadThe SOMECA 300 (TD) is available with four-wheel drive; the URSUS C-328 is two-wheel drive (as stated by the sources).
Which is newer, and what about parts?1972–19781963–1968Ahead (a fact, not an advantage)The SOMECA 300 (TD) is newer: production began 9 years later. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The URSUS C-328 has 94% more hydraulic flow (8.7 L/min / 2.3 gpm) than the SOMECA 300 (TD) (both pump flow, as stated by the source).
  • The URSUS C-328 is 53% heavier (574 kg / 1,265 lb) than the SOMECA 300 (TD) (both unladen weight, as stated by the source).
  • The URSUS C-328 has an independent PTO; the SOMECA 300 (TD)’s is dependent (stops with the clutch).
  • The SOMECA 300 (TD) is available with four-wheel drive; the URSUS C-328 is two-wheel drive (as stated by the sources).
  • The SOMECA 300 (TD) is newer: production began 9 years later. We hold no parts-availability data, so there is no call on parts.
  • Even on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
  • Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on PTO speeds: the same speeds (540 rpm).
  • Not comparable on power at the PTO shaft: the 300 (TD) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the C-328 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, maximum permissible mass and a creeper range.

← Every figure for both machines, side by side, with sources