11 material differences · fewer than 12
Tractor oneSAME Panther 95 (DT)1979–1981No measured PTO figureTractor twoZETOR 9520/95401992–1999No measured PTO figure
Which should you choose?
Read our verdict on the Panther 95 (DT) and the 9520/9540 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
11 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | Panther 95 (DT) | 9520/9540 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 92.7 hp | 92.7 hp | — |
| Engine declared | SAME DA 1055 P | ZBROJOVKA Z-1001 | differs |
| Displacement declared | 5.19 L | 4.16 L | +25% Panther 95 (DT) |
| Maximum torque declared | 251 lb·ft · 340 N·m | 275 lb·ft · 373 N·m | +10% 9520/9540 |
| Transmission | |||
| Top speed declared | 15.5–18.6 mph · 25–30 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Clutch declared | — | Pedal-operated dry single-disc clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | 9.2 gpm · 35.0 L/min | 11.3 gpm · 42.9 L/min | +23% 9520/9540 |
| Pressure declared | — | 3,046 psi · 210 bar | — |
| Three-point lift, at the coupling points declared | 9,348 lb · 4,240 kg | 10,207 lb · 4,630 kg | +9% 9520/9540 |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 7,242 lb · 3,285 kg | 8,157 lb · 3,700 kg | +13% 9520/9540 |
| Maximum permissible mass declared | — | 16,535 lb · 7,500 kg | — |
| Wheelbase declared | 98.4 in · 2,500 mm | 93.5 in · 2,375 mm | +5% Panther 95 (DT) |
| Length declared | 161.4 in · 4,100 mm | 165.0 in · 4,190 mm | — |
| Width declared | 82.7–102.4 in · 2,100–2,600 mm | 76.8–88.6 in · 1,950–2,250 mm | differs |
| Ground clearance declared | 17.9 in · 455 mm | 13.9 in · 352 mm | +29% Panther 95 (DT) |
| Turning radius, braked declared | 12.4 ft · 3.77 m | 12.2 ft · 3.73 m | — |
| Fuel tank declared | 101.4 qt · 96.0 L | 111.0 qt · 105.0 L | +9% 9520/9540 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
SAME Panther 95 (DT) sources
- Source: Traktorenlexikon, “SAME Panther 95”
ZETOR 9520/9540 sources
- Source: Traktorenlexikon, “Zetor 9520/9540”