SAME Atlanta-V (DT) or URSUS 4011?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the Atlanta-V (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 4011 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- The URSUS 4011 suits loader and hydraulic implement work better on this data: 67% (8.0 L/min / 2.1 gpm) more hydraulic flow.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | Atlanta-V (DT) | 4011 | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 30.9 kW (41.4 hp)Traktorenlexikon, “SAME Atlanta V (DT)” | 30.9 kW (41.4 hp)Traktorenlexikon, “Ursus C-4011” | Not comparableNot comparable on power at the PTO shaft: the Atlanta-V (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 4011 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the Atlanta-V (DT) and the 4011. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the Atlanta-V (DT) and the 4011. |
| Which pumps more oil for implements? | 12.0 L/min (3.2 gpm)Traktorenlexikon, “SAME Atlanta V (DT)” | 20.0 L/min (5.3 gpm)Traktorenlexikon, “Ursus C-4011” | AheadThe URSUS 4011 has 67% more hydraulic flow (8.0 L/min / 2.1 gpm) than the SAME Atlanta-V (DT) (both pump flow, as stated by the source). |
| Which lifts more on the three-point hitch? | — | 1,200 kg (2,646 lb)Traktorenlexikon, “Ursus C-4011” | No figureNo call on three-point lift: no figure on record for the Atlanta-V (DT). |
| Which is heavier, for traction? | 1,580 kg (3,483 lb)Traktorenlexikon, “SAME Atlanta V (DT)” | 2,100 kg (4,630 lb)Traktorenlexikon, “Ursus C-4011” | Ahead (a fact, not an advantage)The URSUS 4011 is 33% heavier (520 kg / 1,146 lb) than the SAME Atlanta-V (DT) (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | — | — | No figureNo call on maximum permissible mass: no figure on record for the Atlanta-V (DT) and the 4011. |
| Which has the wider choice of gears? | 6 to 9Traktorenlexikon, “SAME Atlanta V (DT)” | 10Traktorenlexikon, “Ursus C-4011” | EvenEven on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the Atlanta-V (DT) and the 4011. |
| Which is faster on the road? | 25 km/h (15.5 mph)Traktorenlexikon, “SAME Atlanta V (DT)” | 25 km/h (15.5 mph)Traktorenlexikon, “Ursus C-4011” | EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which offers more PTO speeds? | 540 rpmTraktorenlexikon, “SAME Atlanta V (DT)” | 540 rpmTraktorenlexikon, “Ursus C-4011” | EvenEven on PTO speeds: the same speeds (540 rpm). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “SAME Atlanta V (DT)” | — | No figureNo call on PTO independence: not stated for the 4011. |
| Which drives on both axles? | Two-wheel or four-wheel driveTraktorenlexikon, “SAME Atlanta V (DT)” | 2WDTraktorenlexikon, “Ursus C-4011” | AheadThe SAME Atlanta-V (DT) is available with four-wheel drive; the URSUS 4011 is two-wheel drive (as stated by the sources). |
| Which is newer, and what about parts? | 1965–1968 | 1965–1970 | EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The URSUS 4011 has 67% more hydraulic flow (8.0 L/min / 2.1 gpm) than the SAME Atlanta-V (DT) (both pump flow, as stated by the source).
- The URSUS 4011 is 33% heavier (520 kg / 1,146 lb) than the SAME Atlanta-V (DT) (both unladen weight, as stated by the source).
- The SAME Atlanta-V (DT) is available with four-wheel drive; the URSUS 4011 is two-wheel drive (as stated by the sources).
- Even on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
- Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on PTO speeds: the same speeds (540 rpm).
- Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
- Not comparable on power at the PTO shaft: the Atlanta-V (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 4011 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, three-point lift, maximum permissible mass, a creeper range and PTO independence.
← Every figure for both machines, side by side, with sources